A Reflective-Mode Phase-Variation Displacement Sensor
IEEE Access, 2020 In this paper, a displacement sensor based on an open-ended step-impedance transmission line is reported. The sensor operates in reflection, and the output variable is the phase of the reflection coefficient.
Jonathan Munoz-Enano +4 more
doaj +6 more sources
Comparative Analysis of Additional Measurement Error Introduced by Inductive Current Transformers, Rogowski Coils and Electronic Current Transducer for Harmonics of Distorted Current [PDF]
SensorsThis paper investigates the accuracy of conventional inductive current transformers (iCTs) and Rogowski coils (RCs) in measuring distorted currents, evaluating compliance with the WB0 (up to the 13th harmonic) and WB1 (up to the 60th harmonic) accuracy ...
Michal Kaczmarek +2 more
doaj +2 more sources
Influence of Dead-Time on the Input Current Ripple of Three-Phase Voltage Source Inverter
Energies, 2023 The DC-link capacitor in power electronic systems is one of the most vulnerable components in terms of reliability. Since a reliable design of the DC-link capacitor depends on an accurate estimation of its current ripple, this paper proposes analytical ...
Juris Arrozy +4 more
doaj +1 more source
IEEE Access, 2022 This paper investigates for transformation of the distorted current the low order higher harmonic self-generation phenomenon of tested inductive current transformers.
Michal Kaczmarek, Ernest Stano
doaj +1 more source
Energies, 2022 In this paper the design of the two channel opto-isolation circuit for measurements of the differential voltage is presented. It is used to ensure high impedance of the measuring channel(s) in the differential system to ensure the rated operation of ...
Michal Kaczmarek
doaj +1 more source
A harmonic suppression strategy for grid-connected inverters based on quadrature sinewave extractor
Frontiers in Energy Research, 2022 Grid-connected inverters need to reduce current harmonics as much as possible. After introducing the input signal’s fundamental and main harmonic quadrature components, a discrete state model is created, and the discrete observer design method is used to
Yan Xia +7 more
doaj +1 more source
Energies, 2022 This manuscript presents performed laboratory studies and the analysis of the impact of current shunt values used in the differential connection on the wideband metrological performance of inductive current transformers.
Michal Kaczmarek +2 more
doaj +1 more source
Why Should We Test the Wideband Transformation Accuracy of Inductive Current Transformers?
Energies, 2022 Inductive current transformers are characterized by different transformation accuracies for higher harmonics of distorted primary currents. Therefore, it is highly required to perform the tests of their metrological properties to choose the best unit ...
Ernest Stano +2 more
doaj +1 more source
Transformation of Transient Overvoltages by Inductive Voltage Transformers
Sensors, 2021 Overvoltage transients occur after any type of switching activity in a power network, such as breaker operation, fault occurrence/clearance and rapid load change. This distortion of voltage is transformed to the secondary circuit of a voltage transformer.
Michał Kaczmarek, Dariusz Brodecki
doaj +1 more source
Determining the Amount of Earthquake Displacement Using Differential Synthetic Aperture Radar Interferometry (D-InSAR) and Satellite Images of Sentinel-1 A: A Case Study of Sarpol-e Zahab City [PDF]
Advances in Engineering and Intelligence Systems, 2022 One of the effects of an earthquake is the creation of displacement on the land surface. It’s important to determine displacement due to natural disasters such as earthquakes.
Jacob Cherian
doaj +1 more source