Functional Segregation of Epileptogenicity within the Human Amygdala. [PDF]
Feys O +14 more
europepmc +1 more source
Tailoring Functional Properties of Ti–Ni–Cu Shape Memory Alloy Thin Films for MEMS Actuators
A comprehensive study of critical parameters required to develop well‐performing Ti–Ni–Cu thin film shape memory alloy microactuators is provided. Materials science and device integration aspects are integrated by addressing structural and physical relationships using complementary characterization techniques as well as a practical fabrication solution
Elaheh Akbarnejad +6 more
wiley +1 more source
Commentary on German et al.: Qualitative inquiry reduces lags in scientific discovery-to-practice by recognizing the living expertise of people who use drugs. [PDF]
Reed MK.
europepmc +1 more source
Creep‐Induced Microstructural Evolution in an A2‐B2 Superalloy
A 27.3Ta‐27.3Mo‐27.3Ti‐8Cr‐10Al (at.%) refractory high‐entropy alloy with precipitation‐strengthened A2‐B2 microstructure was studied by creep tests at 1030°C, which demonstrate a transition in deformation mechanisms in the range of 100–150 MPa applied stress. This is associated with changes in dislocation–precipitate interactions. Relevant deformation
Liu Yang +10 more
wiley +1 more source
Correction for Cheng and Yu, Integrating generative AI and physical tests to strengthen claims about emergent phenomena. [PDF]
europepmc +1 more source
Surface Engineering in Materials (2nd Edition). [PDF]
Richert M.
europepmc +1 more source
Influence of Test Temperature and Test Frequency on Fatigue Life of Aluminum Alloy EN AW‐2618A
The influence of test temperature and test frequency on the fatigue life of EN AW‐2618A is investigated. High‐cycle fatigue tests are performed at different test temperatures and frequencies on the 1000 h/230°C overaged state. Both test parameters reduce fatigue life due to time‐dependent damage mechanisms.
Ying Han +5 more
wiley +1 more source
Rock-paper-scissors interactions enable thermal localization. [PDF]
Li J, Qiu CW.
europepmc +1 more source
Creep Properties and Deformation Mechanism of Additively Manufactured NiAl‐CrMo Composites
Additively manufactured NiAl‐CrMo composites contain numerous interfaces and cell boundaries that control their creep response. At 700°C under high applied stress, creep is dominated by dislocation‐controlled power‐law mechanisms. At 800°C–900°C and lower stresses, creep is primarily diffusion‐controlled along cell boundaries.
Jan Vollhüter +9 more
wiley +1 more source
Placebo and Nocebo Phenomena in Schizophrenia Spectrum Disorders: A Narrative Review on Current Knowledge and Potential Future Directions - CORRIGENDUM. [PDF]
Pujji SD, Colloca L, Waltz JA.
europepmc +1 more source

