Results 31 to 40 of about 11,935 (238)
Graphene-based Materials for Photoanodes in Dye-sensitized Solar Cells
Frontiers in Energy Research, 2015 This article reviews the research on the use of graphene and related materials in the photoanode of dye-sensitized solar cells (DSSCs). Graphene-based materials, such as pristine graphene, graphene oxide, and reduced graphene oxide, have properties ...
Xiaoru eGuo, Ganhua eLu, Junhong eChen
doaj +1 more source
Advanced Materials Interfaces, 2023 Severe surface photocarrier recombination and poor electronic conductivity are the major factors behind the sluggish photoelectrochemical water oxidation kinetics of the ZnFe2O4 photoanode.
Dipanjan Maity +7 more
doaj +1 more source
Pakistan Journal of Analytical & Environmental Chemistry, 2023 Increasing developments on the application of copper complexes as dyes are due to their dual function in dye-sensitized solar cells (DSSCs) as redox mediators and dye sensitizers.
Anis Kharul Nada Mohd Yusuf +6 more
doaj +1 more source
Self-assembled photonic mesostructures for water splitting photoanodes [PDF]
, 2015 Solar water splitting is a relevant principle for the production of green hydrogen fuel. A wealth of different designs has been envisioned to produce hydrogen using sunlight.
Boudoire, Florent
core +1 more source
Photocorrosion Mechanism of TiO2-Coated Photoanodes [PDF]
International Journal of Photoenergy, 2015 Atomic layer deposition was used to coat CdS photoanodes with 7 nm thick TiO2films to protect them from photocorrosion during photoelectrochemical water splitting. Photoelectrochemical measurements indicate that the TiO2coating does not provide full protection against photocorrosion.
Didden, A. +3 more
openaire +3 more sources
Atomically thin photoanode of InSe/graphene heterostructure [PDF]
Nature Communications, 2021 AbstractAchieving high-efficiency photoelectrochemical water splitting requires a better understanding of ion kinetics, e.g., diffusion, adsorption and reactions, near the photoelectrode’s surface. However, with macroscopic three-dimensional electrodes, it is often difficult to disentangle the contributions of surface effects to the total photocurrent ...
Haihong Zheng +10 more
openaire +4 more sources
Enhancing DSSC conversion efficiency by ozone-treated TiO2 photoanode and optimum CNT/PDDA counter electrode [PDF]
, 2020 The conversion efficiency of dye-sensitized solar cells (DSSCs) depends on the performance of the photoanode and the counter electrode. In this paper, UV-ozone treatment has been applied to the photoanode to clean and increase the hydrophilicity of the ...
Kurokawa, Yoshiki +3 more
core +2 more sources
Nanomaterials, 2023 Five Covalent Organic Frameworks (COFs) were synthesized and applied to Dye-Sensitized Solar Cells (DSSCs) as dyes and additives. These porous nanomaterials are based on cheap, abundant commercially available ionic dyes (thionin acetate RIO-43, Bismarck ...
Diogo Inácio +5 more
doaj +1 more source
Research Progress of Photoanodes for Quantum Dot Sensitized Solar Cells
Cailiao gongcheng, 2017 This paper presents the development status and tendency of quantum dot sensitized solar cells. Photoanode research progress and its related technologies are analyzed in detail from the three ways of semiconductor thin films, quantum dot co-sensitization ...
LI Zhi-min +4 more
doaj +1 more source
Back-illuminated dye sensitized solar cell flexible photoanode on titanium foil [PDF]
, 2019 This paper reports the preparation and performance analysis on dye-sensitized solar cells (DSSC) using titanium (Ti) foil as flexible photoanode for back-illuminated measurement. Performance differences were also carried with the fluorine-doped tin oxide
Ahmad, Fauzan +6 more
core +1 more source