Results 41 to 50 of about 227,636 (314)
Nanoscale Research Letters, 2018 The development of p-type metal oxide thin-film transistors (TFTs) is far behind the n-type counterparts. Here, p-type CuAlO2 thin films were deposited by spin coating and annealed in nitrogen atmosphere at different temperature.
Shuang Li +5 more
doaj +1 more source
Advanced Functional Materials, EarlyView.Solvent vapor annealing enables kinetic control of additive‐free morphology in organic solar cells. Selective plasticization of acceptor forms an optimal fibrillar network, boosting efficiency to 19.06% (binary) and 19.75% (ternary), with ultrafast exciton dissociation and reduced recombination.
Jie Lv +20 more
wiley +1 more source
Photoconductivity in self-assembled CuO thin films
Materials for Renewable and Sustainable EnergySelf-assembly is the most promising low-cost and high-throughput methodology for nanofabrication. This paper reports the optimization of a self-assembly process at room temperature for the growth of copper oxide (CuO) based nanostructures over a copper ...
Akhil M. Anand +4 more
doaj +1 more source
Quality Analysis of Photovoltaic System Using Descriptive Statistics of Power Performance Index
IEEE Access, 2023 The performance evaluation (PE) of the Photovoltaic(PV) system is an index representing the efficiency and reliability of the system. Most PE indicators evaluate the ratio of theoretically calculated power generation to actually measured power generation.
Gyu Gwang Kim +5 more
doaj +1 more source
Advanced Functional Materials, EarlyView.Metasurfaces and other structured photonic environments can dramatically modify the absorption and/or light emission of semiconductors. However, the consequences of these changes on the temperature of the system are not well understood. The authors address this problem for colloidal nanocrystals and leverage their findings to convert light into ...
Hugo Kowalczyk +7 more
wiley +1 more source
Ultra low-power photovoltaic MPPT technique for indoor and outdoor wireless sensor nodes [PDF]
, 2011 Photovoltaic (PV) energy harvesting is commonly used to power wireless sensor nodes. To optimise harvesting efficiency, maximum power point tracking (MPPT) techniques are often used.
Weddell, Alex +5 more
core +1 more source
AIP Advances, 2018 Al2O3 is the standard for the passivation of p-type PERC (Passivated Emitter Rear Contact) solar cells. It is well established that the thin interfacial silicon oxide layer in between Al2O3 and c-Si plays a key role in its surface passivation mechanism ...
C.-Y. Lee +6 more
doaj +1 more source
Advanced Functional Materials, EarlyView.Tandem organic solar cells with optimized ternary acceptor engineering achieved a power conversion efficiency of 15.53% and enabled a high‐voltage mini‐module (Voc 6.11 V). Integration into a bias‐free PV‐EC system further demonstrated efficient solar‐to‐ammonia (STA) conversion (97% Faradaic Efficiency, 4± 2% STA efficiency), highlighting scalable ...
Seyeong Song +11 more
wiley +1 more source
Electrical Impact Of Photovoltaic Plant In Distributed Network [PDF]
, 2009 This paper presents the problem of power penetration of photovoltaic (PV) systems in urban networks. After a qualitative problem description, two different environments for PV systems have been analyzed: rural and urban networks.
Tartaglia, Michele +3 more
core +1 more source
Exploring the PV Power Forecasting at Building Façades Using Gradient Boosting Methods
Energies, 2023 Solar power forecasting is of high interest in managing any power system based on solar energy. In the case of photovoltaic (PV) systems, and building integrated PV (BIPV) in particular, it may help to better operate the power grid and to manage the ...
Jesús Polo +5 more
doaj +1 more source