Results 81 to 90 of about 8,704 (249)

Engineering Large‐Grain Metal Halide Perovskite Films via Chemical Vapor Deposition for High‐Performance, Ultralow‐Noise Perovskite Photodetectors

open access: yesAdvanced Science, EarlyView.
Chemical vapor deposition produces large‐grain, phase‐pure CsPbBr3 films (grains up to 35 µm) with Drude‐like terahertz photoconductivity and twofold higher carrier mobility versus spin‐coated references. These microstructural advances translate into photodetectors with a detectivity of 8.4 × 1012 Jones, dark current below 1 pA cm−2, X‐ray sensitivity ...
Roel Vanden Brande   +14 more
wiley   +1 more source

Graphene‐Engineered Rear Interfaces Enable Efficient Flexible CZTSSe Solar Cells on Metal Foils

open access: yesAdvanced Science, EarlyView.
An atomically thin graphene interlayer stabilizes the rear interface of flexible CZTSSe solar cells by regulating interfacial stress, suppressing detrimental interfacial reactions, and reducing the back‐contact barrier. This strategy simultaneously improves photovoltaic performance and mechanical durability.
Yixiong Ji   +18 more
wiley   +1 more source

Defect detection of photovoltaic modules based on improved VarifocalNet

open access: yesScientific Reports
Detecting and replacing defective photovoltaic modules is essential as they directly impact power generation efficiency. Many current deep learning-based methods for detecting defects in photovoltaic modules focus solely on either detection speed or ...
Yanfei Jia, Guangda Chen, Liquan Zhao
doaj   +1 more source

Thermal‐Ionic Coupling in Transpiration‐Inspired Janus Nanofiber Membranes: Synergistic Dry‐Wet Interface Engineering for Solar‐Driven Electricity Generation

open access: yesAdvanced Science, EarlyView.
A transpiration‐inspired Janus nanofiber membrane creates a persistent dry‐wet interface that couples localized solar heating with hydration‐induced ion regulation. The asymmetric architecture sustains directional water and ion transport, suppresses salt accumulation, and enables simultaneous seawater evaporation and stable electricity generation ...
Qin Su   +10 more
wiley   +1 more source

Unveiling a Near‐Total Rear Passivation for High Performance of Ultra‐Thin ACIGS

open access: yesAdvanced Science, EarlyView.
Ultra‐thin solar cells of (Ag,Cu)(In,Ga)Se2 (ACIGS) suffer from rear interface recombination, limiting their performance. To tackle it, a full coverage plasma enhanced chemically vapor‐deposited 8 nm porous SiOx passivation layer was implemented and evaluated. It is shown that a combination of the near‐complete passivation from silica and the formation
Xavier L. Pinheiro   +7 more
wiley   +1 more source

Advances in Se Wide‐Bandgap Photovoltaics and TexSe1‐x SWIR Photodiodes

open access: yesAdvanced Science, EarlyView.
In this review, fundamental properties and current challenges in Se photovoltaics (PVs) for tandem and indoor PVs and TexSe1‐x alloys for short wave infrared photodiodes are discussed. A case is made for the practicality of elemental chalcogenide optoelectronics, and a pathway toward resolving the key challenges in these respective technologies is ...
Adam D. Alfieri, Deep Jariwala
wiley   +1 more source

Influence of Lamination Conditions of EVA Encapsulation on Photovoltaic Module Durability. [PDF]

open access: yesMaterials (Basel), 2023
Wu D   +6 more
europepmc   +1 more source

From Sensing Mechanisms to System Co‐Design: Graphene‐Based Sensors and Readout Circuits

open access: yesAdvanced Science, EarlyView.
This review establishes a unified PS–EQ–RF framework linking graphene sensing mechanisms, native electrical outputs, and output‐specific readout circuits. Voltage‐, current‐, resistance‐, and capacitance‐type sensing systems are systematically classified to guide architecture selection, low‐noise design, system co‐design, and practical integration ...
Jinduo Zhang   +5 more
wiley   +1 more source

Development of assessment methods for photovoltaic module enhancing techniques using the lifespan parameter. [PDF]

open access: yesHeliyon, 2023
M Sultan S   +6 more
europepmc   +1 more source

Rapid Cooling After Device Annealing Suppresses Interface Losses in Cu2ZnSnS4 Solar Cells Enabling High Efficiency and Stability

open access: yesAdvanced Science, EarlyView.
Rapid cooling after device annealing regulates the CdS/CZTS heterojunction and Mo/CZTS back contact, suppressing interfacial recombination and modifying the interfacial MoS2 layer, thereby enabling a 15.9% indoor PCE in pure‐sulfide CZTS solar cells.
Achmad Nasyori   +16 more
wiley   +1 more source

Home - About - Disclaimer - Privacy