Results 71 to 80 of about 75,107 (301)
Advanced Functional Materials, EarlyView.ABSTRACT Metal oxide (MOx)‐based NO2 gas sensors typically require high temperatures or ultraviolet light, limiting their practical use. To enable visible‐light activation at room temperature, efficient and stable photosensitizers should be integrated with nanostructured MOx hosts.
Yeonji Yuk +10 more
wiley +1 more source
Fabrication and performance analysis of concentrated hybrid photovoltaic system
MATEC Web of Conferences, 2018 Sun is the most important source of renewable source of energy. During the past few decades there has been an ever-increasing interest in Photovoltaic (PV) cells as it directly converts solar radiation into electricity.
Murthy Krishna +4 more
doaj +2 more sources
Constructive solution of highly effective photoenergy module: development and experimental testing [PDF]
, 2019 Based on experimental study and computermodeling of working temperature influence on the efficiency of Chinese production silicon solar cells identified temperature dependence of efficiency shows the feasibility of using Chinese production Si-SC in the ...
Chugai, O. N. +5 more
core +3 more sources
Novel Functional Materials via 3D Printing by Vat Photopolymerization
Advanced Functional Materials, EarlyView.This Perspective systematically analyzes strategies for incorporating functionalities into 3D‐printed materials via Vat Photopolymerization (VP). It explores the spectrum of achievable functionalities in recently reported novel materials—such as conductive, energy‐storing, biodegradable, stimuli‐responsive, self‐healing, shape‐memory, biomaterials, and
Sergey S. Nechausov +3 more
wiley +1 more source
Buildings, 2022 Some recent research in the area of light shelves has been focused on applying photovoltaic modules to light shelves to save building energy. However, due to the modules installed on the light shelf reflectors, most such light shelves have failed to ...
Heangwoo Lee, Sowon Han, Janghoo Seo
doaj +1 more source
Degradation effects in sc-Si PV modules subjected to natural and induced ageing after several years of field operation [PDF]
, 2012 This paper presents ageing effects observed in sc-Si PV modules operating in field conditions for 18 and over 22 years. The effects of both natural ageing processes and induced ageing by external agents, causing partial or total shading of cells for a ...
Kaplani, E.
core
Advanced Functional Materials, EarlyView.The citric acid/urea (CA‐Urea) precursor system offers a versatile, scalable route to carbon dots with tunable luminescence and multifunctionality. Mechanistic insights into precursor chemistry and reaction parameters have enabled doping, surface modification, and hybridization strategies, yielding CDs for luminescent devices, sensing, catalysis ...
Yupeng Liu +10 more
wiley +1 more source
Power Prediction of Bifacial Si PV Module with Different Reflection Conditions on Rooftop
Applied Sciences, 2018 A bifacial solar module has a structure that allows the rear electrode to be added to the existing silicon photovoltaic module structure. Thus, it can capture energy from both the front and rear sides of the module.
Hae Lim Cha +4 more
doaj +1 more source
Solar array fed synchronous reluctance motor driven water pump : an improved performance under partial shading conditions [PDF]
, 2019 An improved performance of a photovoltaic (PV) pumping system employing a synchronous reluctance motor (SynRM) under partial shading conditions is proposed.
Al-Dhaifallah, Mujahed +3 more
core +2 more sources
Aerial Photoluminescence Imaging of Photovoltaic Modules
physica status solidi (RRL) – Rapid Research Letters, 2023 On‐site imaging of modules in photovoltaic (PV) systems requires contact‐free techniques with high throughput and low cost for commercial relevance. Photoluminescence imaging satisfies these requirements, but it has so far not been used for aerial imaging.
Bernd Doll +7 more
openaire +2 more sources