Results 11 to 20 of about 348,840 (245)
Physical and Mechanical Properties of Mycelium-based Fiberboards
BioResourcesMycelium-based fiberboards were evaluated as potential environmentally friendly substitutes for conventional wood-based composites. The goal of this study was to produce and test fiberboards out of yellow pine and poplar fiber mixtures without using any ...
Engin Derya Gezer +2 more
doaj +5 more sources
Physical and mechanical properties of membrane Polyacrylonitrile [PDF]
MATEC Web of Conferences, 2017 Tensile test is a method used to measure the strength of a material by providing the burden of the opposing forces in a straight line. This experiment used to measure a material’s mechanical strength against a static force which is given slowly.
Mataram Agung +3 more
doaj +2 more sources
Physical and Mechanical Properties of Hempcrete [PDF]
The Open Waste Management Journal, 2020 Background:Environment-friendly materials attract attention whilst the construction sector causes excessive global energy consumption and emission of greenhouse gas. Renewable plant-based biomaterials, which have a low environmental impact, are very beneficial in order to prevent environmental pollution and to preserve natural resources.
İsmail Demir, Cüneyt Doğan
openaire +1 more source
Physical and mechanical properties of anaerobic sealants [PDF]
E3S Web of Conferences, 2023 The article presents the main causes of wear on the seats of rolling bearings during operation, which are fretting corrosion and turning of the inner and outer rings of bearings.
Toirov I. J., Batirov Z. L., Razzakov T.
doaj +1 more source
UTILIZATION OF GRAPE PRUNINGS RESIDUES IN PRODUCTION OF PARTICLEBOARD [PDF]
تحقیقات علوم چوب و کاغذ ایران, 2004 The purpose of this study was to examine the utilization of grape lignocellulosic pruning as a raw material in particleboard manufacturing. Experimental boards were produced with using grape wood particles, resin content (UF resin) at 10 and 12% and ...
Abolfazl Kargarfard, Amir Nourbakhsh
doaj +1 more source
Metals, 2017 The structure–property relationship was studied in an Fe-18Mn-0.6C-1.5Al steel subjected to cold rolling to various total reductions from 20% to 80% and subsequent annealing for 30 min at temperatures of 673 to 973 K.
Alexander Kalinenko +4 more
doaj +1 more source
VARIATION IN PHYSICAL AND MECHANICAL PROPERTIES OF OAK (QUEREUS EASTANEAEFOLIA C.A. MEY) IN SANGDEH REGION OF CASPIAN FORESTS [PDF]
تحقیقات علوم چوب و کاغذ ایران, 2002 In this investigation physical and mechanical properties of oak (Quercus castaneaefolia C.A. Mey) in Sangdeh region of Caspian Forests were measured according to the ASTM Standard D-143-83 for small samples.
Abdolrahman Hosseinzadeh +1 more
doaj +1 more source
The Study of Pulp-Polypropylene biocomposites Properties produced from non-extracted and pre-extracted Bagasse with hot water [PDF]
تحقیقات علوم چوب و کاغذ ایران, 2016 In this study, the physical and mechanical properties of polypropylene composites reinforced with alkaline sulfite-anthraquinone, soda-anthraquinone and monoethanolamine-anthraquinone and chemical mechanical produced from non-extrated and pre-extracted ...
Alireza Sokhtesaraei +4 more
doaj +1 more source
Physical and Mechanical Properties of Reaction Wood [PDF]
, 2013 Reaction wood produces very peculiar maturation stresses at the tree periphery i.e. compressive stress or very high tensile stress, for compression and tension wood respectively, as compared to moderately high tensile stress for normal wood. This means that both its mechanical state and its mechanical and physical properties differ from normal wood ...
Clair, Bruno, Thibaut, Bernard
openaire +3 more sources
Feasibility of utilizing polypropylene as a binder for plywood manufacture [PDF]
تحقیقات علوم چوب و کاغذ ایران, 2009 In this study, plywood manufacture with use of polypropylene as a binder has been studied. The variables were polypropylene in three levels of 80, 120 and 160 g/m2 and maleic anhydride polypropylene coupling agent in two levels of 0 and 4 g/m2 ...
Ali akbar Enayati +2 more
doaj +1 more source