Results 1 to 10 of about 2,350,673 (316)
Structural and electronic properties of β-MnO2 nanoclusters [PDF]
MATEC Web of Conferences, 2022 Pyrolusite (β-MnO2) was investigated for potential use in energy storage devices due to its promising properties for cathode materials in rechargeable lithium-ion batteries. A combination of evolutionary algorithm search techniques and density functional
Masoga Wesley P. +2 more
doaj +1 more source
Bursting Phenomenon and Chaos Phase Control in Plant Dynamics
Complexity, 2023 New complex features of a Pinus family plant subjected to wind load by proposing an analog electronic simulator with an active RC realization that mimics the real-time dynamics of the system was examined in this paper.
Makenne Yemeli Lola +2 more
doaj +1 more source
Fluids, 2022 The development of energy-efficient solutions for large-scale fermenters demands a deep and comprehensive understanding of hydrodynamic and heat and mass transfer processes.
Ilya Starodumov +8 more
doaj +1 more source
Physical System Modeling [PDF]
Journal of Dynamic Systems, Measurement, and Control, 2010 603011
Stein, J. L. +5 more
openaire +2 more sources
Energy Conversion and Management: X, 2022 In this paper, the two-diode circuit model with seven parameters is used to model the electrical properties and the physical effects of photovoltaic modules. In this article, only the available information about the photovoltaic panel on its manufacturer’
Kawtar Tifidat +3 more
doaj +1 more source
Optimization of the Young's modulus of woven composite material made by Raphia vinifiera fiber/epoxy
International Journal for Simulation and Multidisciplinary Design Optimization, 2022 This work focuses on the optimal design of the woven fabrics made from Raphia vinifiera, fiber, and their contribution as reinforcing element in the epoxy matrix. The work is done alternately experimentally and theoretically.
Kendem Djoumessi Alfred +4 more
doaj +1 more source
Energy Conversion and Management: X, 2023 The evaluation of photovoltaic device performance is based on the I-V characteristic curve. Unfortunately, the data sheets provided by the manufacturers only include data at standard test conditions, which requires the construction of a model capable of ...
Imade Choulli +8 more
doaj +1 more source
Greatly enhancing the modeling accuracy for distributed parameter systems by nonlinear time/space separation [PDF]
, 2006 An effective modeling method for nonlinear distributed parameter systems (DPSs) is critical for both physical system analysis and industrial engineering.
Boyd +33 more
core +2 more sources
Influence of Soap Factory Wastewater on the Physical and Mechanical Performance of Concrete
Diyala Journal of Engineering Sciences, 2022 The management of water resources is one of the major priorities in all countries of the world and even more so in developing countries such as Cameroon.
Zoyem Gouafo Mathurin +4 more
doaj +1 more source
A review on the Mullins effect [PDF]
, 2009 The Mullins’ effect remains a major challenge in order to provide good mechanical modeling of the complex behavior of industrial rubber materials. It’s been forty years since Mullins [1] wrote his review on the phenomenon and still no general agreement ...
DIANI, Julie +2 more
core +2 more sources