Results 71 to 80 of about 78,093 (307)
Performance of shallow anchor in ice-rich silt [PDF]
, 2014 Thesis (M.S.) University of Alaska Fairbanks, 2014Shallow anchor systems have been widely used for decades due to their time and cost efficiency. Yet when it comes to cold regions like Alaska, new challenges caused by the harsh environment need to be ...
Lin, Chuang, 林闯
core
Thermoreflectance Detection of Point Defects Resulting from Focused Ion Beam Milling
Advanced Engineering Materials, EarlyView.Focused ion beam (FIB) milling is a common tool for nanoscale material processing, however irradiation damage, redeposition, and contamination can occur. We use several characterization tools to show FIB‐induced effects beyond 1 mm from the milled area.
Thomas W. Pfeifer +3 more
wiley +1 more source
Measuring horizontal stresses during jacked pile installation [PDF]
, 2015 Jacking is an installation technique for displacement piles which is commonly used onshore in urban environments owing to its low noise and vibration.
, +4 more
core +1 more source
Harnessing Fungal Biowelding for Constructing Mycelium‐Engineered Materials
Advanced Engineering Materials, EarlyView.Mycelium‐bound composites (MBCs) offer low‐carbon alternatives for construction, yet interfacial bonding remains a critical challenge. This review examines fungal biowelding as a biocompatible adhesive, elucidating mycelium‐mediated interfacial mechanisms and their role in material assembly. Strategies to optimize biowelding are discussed, highlighting
Xue Brenda Bai +2 more
wiley +1 more source
Factors Influencing the Prediction of Pile Driveability Using CPT-Based Approaches
Energies, 2020 This paper investigates the applicability of Cone Penetration Test (CPT)-based axial capacity approaches, used for estimating pile static capacity, to the prediction of pile driveability.
Luke J. Prendergast +2 more
doaj +1 more source
Installation of prestressed spun high strength concrete piles by hydraulic jacking [PDF]
, 2014 Theme: Challenges and Recent Advance in Geotechnics for Foundation EngineeringThe technique of hydraulic jacking has been applied to install prestressed spun high strength concrete PHC) piles in Macau.
Yeung, AT
core
Advanced Engineering Materials, EarlyView.Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source
Results of monitoring at the British library excavation [PDF]
, 2014 The main phase of excavation for the basements of the British Library at St Pancras, London, was completed in 1987. The project included basements extending up to 25 m deep, through the London Clay and into the Lambeth Group. The excavations were formed
Simpson, Brian, Vardanega, Paul J.
core +2 more sources
Handbook of Establishing and Maintaining Oxygen‐Free Atmospheres
Advanced Engineering Materials, EarlyView.This study presents a practical framework for creating oxygen‐free atmospheres at ambient pressure using silane‐doped inert gases. The results show that ultra‐low oxygen levels and strongly reduced water content can be achieved through controlled silane dosing, drying systems, and sensor monitoring.
Sascha Jan Zimmermann +3 more
wiley +1 more source
Soils and FoundationsUp to this day, there are great uncertainties in the design procedures of monopiles, especially concerning the soil state condition and penetration response during their installation.
Michail Spyridis, Susana Lopez-Querol
doaj +1 more source