Results 101 to 110 of about 14,734 (291)

Tooth surface mismatch design of cycloidal bevel gear based on two directions modification of pinion cutter

Journal of Advanced Mechanical Design, Systems, and Manufacturing
Aiming at the sensitivity of installation errors caused by the complete conjugated tooth surface of cycloidal bevel gear, a method of tooth surface mismatch design which only modified the pinion cutter along two directions was proposed.
Shaowu NIE, Jinyu CHEN, Zhengyang HAN
doaj   +1 more source

Making AI Work: A Critical Theory of AI Production

Constellations, Volume 33, Issue 2, Page 285-296, June 2026.
Rosalie Waelen, Jean‐Philippe Deranty
wiley   +1 more source

Research on noise reduction of drive axle hypoid gear based on tooth surface mismatch modification

Advances in Mechanical Engineering
In order to reduce the transmission noise of drive axle hypoid gear, a method of tooth surface mismatch modification was proposed. Firstly, on the basis of establishing the grinding mathematical model of hypoid gear with cutter tilt, the theoretical ...
Shaowu Nie, Jinyu Chen, Shaohang Liu
doaj   +1 more source

Making the hole square

, 2004
Janine Pinion maps the road travelled so far in creating a helpful environment for students with mental health problems (and the staff who support them) at Wirral Metropolitan College.
Janine Pinion
core   +1 more source

Contact Analysis and Tooth Profile Optimization Design of Rack and Pinion for Rack-rail Trains Based on the Finite-length Line Contact Theory

Jixie chuandong
In order to investigate the influence of the error of center distance between the driving pinion and rack track meshing and the error of axis non-parallelism on the contact stress distribution during the curved driving of rack-rail trains, an analytical ...
Lei Huanhuan, Zhao Jiadong, Zhi Yanfeng, Shi Lubing, Zhao Yukai, Yue Zihao   +5 more
doaj  

Douglas Pinion, Wednesday, November 16, 1977 [PDF]

, 1977

core  

Douglas Pinion, Friday, March 10, 1978 [PDF]

, 1978

core  

AUTO-MESHING RACK AND PINION GEAR

, 2020
In a mechanical system with a rack and pinion, typically the rack and pinion are always engaged with each other but, in some instances, it is necessary to have the pinion gear disengage and engage with the rack.
INC, HP
core  

RESEARCH ON GEAR TOOTH INTERFERENCE PROBLEM OF SINGLE DRIVE MULTI-POINT MESHING RACK AND PINION TRANSMISSION

Jixie qiangdu
The load capacity of the rack and pinion mechanism is limited by the contact strength of the gear tooth surface.In order to improve its load capacity,multiple pairs of gears and single rack meshing were adopted.In order to simplify the structure of the ...
doaj  

Douglas Pinion, February 9, 1981 [PDF]

, 1981

core