Results 191 to 200 of about 733,397 (341)

Microstructural and Electrochemical Study: Pitting Corrosion Mechanism on A390 Al-Si Alloy and Ce-Mo Treatment as a Better Corrosion Protection. [PDF]

open access: yesMaterials (Basel)
Herrera Hernández H   +6 more
europepmc   +1 more source

Effect of Heat Treatment Parameters on Microstructure, Hardness, and Corrosion Resistance of Martensitic Stainless Steel X30Cr13 (AISI 420B)

open access: yesMaterials and Corrosion, EarlyView.
The hardness and corrosion resistance of the martensitic stainless steel X30Cr13 depend directly on the applied heat treatment. This article describes and discusses the relationships between alloy composition, thermodynamic phase stabilities, heat treatment parameters, resulting microstructures, and achievable corrosion resistance. To investigate these
Adrian Evia Ocampo   +3 more
wiley   +1 more source

Failure Investigation of Alloy 625 Sockolets After Prolonged Service in an Ammonia Cracker Unit

open access: yesMaterials and Corrosion, EarlyView.
The failure of the sockolets was caused by intergranular cracking and fracture. The thick and highly brittle nitrided layer formed intergranular surface cracks, which propagated along grain boundaries into the base alloy substrate due to the presence of brittle Cr‐rich carbides. ABSTRACT Several sockolets of Alloy 625 operating at 540°C in contact with
Kamlesh Chandra   +2 more
wiley   +1 more source

Critical role of slags in pitting corrosion of additively manufactured stainless steel in simulated seawater. [PDF]

open access: yesNat Commun
Sen-Britain S   +11 more
europepmc   +1 more source

Anaerobic Corrosion Phenomena of Cast Iron and Copper in Artificial Groundwater at Elevated Temperature

open access: yesMaterials and Corrosion, EarlyView.
This study examines corrosion of copper and cast iron as candidate canister materials for high‐level radioactive waste disposal in contact with bentonite suspension. The influence of three electrolyte compositions on corrosion behavior under repository‐relevant conditions is assessed.
Louisa Panjiyar   +2 more
wiley   +1 more source

Experimental and Comparative Study of the Corrosion Behavior of Lean Duplex Stainless Steel in Seawater

open access: yesMaterials and Corrosion, EarlyView.
The localized corrosion behavior of lean duplex stainless steel EN 1.4062 is systematically compared with austenitic and higher‐alloyed duplex grades in natural seawater. A clear resistance ranking is established, highlighting EN 1.4062 as a cost‐effective alternative for limited marine exposure.
Mohammad Hassanzadeh   +4 more
wiley   +1 more source

Chromium Salt: A Review of Salt Formation, Hygroscopic Properties, and Impact on 316 L Corrosion in Hydrochloric Acid

open access: yesMaterials and Corrosion, EarlyView.
This article examines the impact of externally introduced chromium compounds on the localized corrosion of 316 L stainless steel in acidic chloride environments such as hydrochloric acid. While the corrosion resistance of 316 L relies on the formation of a chromium‐rich passive oxide layer, industrial conditions may expose the steel to various chromium
Florence Lequien
wiley   +1 more source

Home - About - Disclaimer - Privacy