Results 11 to 20 of about 131,786 (274)
Integrated modelling: Coupling of surface evolution and plasma-impurity transport
During the interaction of the scrape off layer (SOL) plasma with the first wall the evolution of both wall and plasma are tightly coupled: The erosion of the first wall leads to an impurity concentration in the plasma which affects the particle and power
K. Schmid +19 more
doaj +1 more source
Plasma surface interactions in impurity seeded plasmas [PDF]
Abstract With tokamak devices developing towards higher heating powers, and carbon plasma facing components being increasingly replaced by high-Z materials like tungsten, impurity seeding for radiative power dissipation gains more importance. This review summarizes the core and divertor radiative characteristics of potential seeding species, namely ...
Kallenbach, A. +199 more
openaire +4 more sources
First impurity powder injection experiments in LHD
Injection of impurities in the form of sub-millimeter powder grains is performed for the first time in the Large Helical Device (LHD) plasma, employing the Impurity Powder Dropper (IPD) (Nagy et al., 2018), developed and built by PPPL. Controlled amounts
F. Nespoli +15 more
doaj +1 more source
Charge dependence of neoclassical and turbulent transport of light impurities on MAST [PDF]
Carbon and nitrogen impurity transport coefficients are determined from gas puff experiments carried out during repeat L-mode discharges on the Mega-Amp Spherical Tokamak (MAST) and compared against a previous analysis of helium impurity transport on ...
Casson, F. J. +10 more
core +4 more sources
Effect of Impurity Reduction on Mechanical Properties of Fe29.5Ti70.5 Alloy Prepared by Pretreated Ti Scraps [PDF]
Ferrotitanium can be produced as a method of recycling Ti scraps. The eutectic composition of ferrotitanium, Fe29.5Ti70.5, can be obtained as a nanocrystalline phase due to relatively low melting point. Fe29.5Ti70.5 in which FeTi and β-Ti form a lamellar
Suhwan Yoo +4 more
doaj +1 more source
Cold atmospheric-pressure He + N(2) and He + O(2) plasmas are chosen as the representatives for electropositive and electronegative plasmas, of which the discharge characteristics are studied and then compared to each other by fluid models.
Ding Xin Liu +5 more
doaj +1 more source
The new SAS-VW divertor in DIII-D has tungsten-coated components to enable the study of tungsten erosion and leakage from a closed, slot-like divertor. A proposed method of actively managing the tungsten impurities is to inject low-Z impurities, such as ...
Matthew S. Parsons +2 more
doaj +1 more source
First investigation on plasma impurities of the IR-T1 tokamak
One of the best ways to get information about plasma and interactions within it, is the study on visible light emitted from plasma. Detection of the emission spectrum from plasma leads to identify the spectral lines of ions and impurities inside the ...
R. Alipour +2 more
doaj +1 more source
On the influence of metal impurities on the electrical conductivity of the dense plasma of pulse electric discharges in water [PDF]
The effect of metal impurities on the electrical conductivity of a dense plasma of discharges in water is considered. Conductivity calculations were based on the method of Grad's moments.
V. V. Hladkovskyi +5 more
doaj +1 more source
To study the potential applications of liquid lithium (Li) as plasma facing material, the third generation of flowing liquid Li (FLiLi) limiter has been designed and successfully tested in EAST tokamak H-mode discharges in the 2018 run campaign.
Z.L. Tang +14 more
doaj +1 more source

