Results 161 to 170 of about 7,280 (262)

Climate Driven Water Table Changes and Their Influence on Liquefaction Response of Integral Bridges

Earthquake Engineering &Structural Dynamics, EarlyView.
ABSTRACT Integral abutment bridges (IABs) eliminate bearings and joints but transfer seismic demand directly into the surrounding soil, making their response highly sensitive to groundwater conditions and soil–structure interaction. This study presents a 60 g centrifuge testing programme on single‐span IABs designed to isolate the influence of water ...
Yazan B. Asia, Gopal S. P. Madabhushi
wiley   +1 more source

A comparative study of modified performance based plastic design methods for seismic design of RC frames: improvement over existing methods. [PDF]

Sci Rep
Vyas R, Sharma R, Emani VV, Batah A, Shirkol AI, Kaushik Gondaliya, Ansari A, Alluqmani AE, Mandhaniya P, Rani V, Rc B.   +10 more
europepmc   +1 more source

Surrogate‐Based Time‐Continuous Seismic Fragility Assessment of Corrosion‐Deteriorated Reinforced Concrete Bridges Under Climate Change

Earthquake Engineering &Structural Dynamics, EarlyView.
ABSTRACT Seismic fragility assessment of reinforced concrete (RC) bridges exposed to corrosive environments must reliably capture time‐dependent deterioration impacts. Climate change compounds this challenge through nonstationary temperature and humidity variations that accelerate bridge corrosion.
Yexiang Yan, Yazhou Xie
wiley   +1 more source

Rapid Detection of Chicken Residues on Poultry Plant Surfaces Using Color and Fluorescence Spectrometry. [PDF]

Foods
Griscom C, Wang D, O'Bryan CA, Rõõm R, Crandall PG.   +4 more
europepmc   +1 more source

An Intensity Measure‐Based Methodology for Ground Motion Orientation in Seismic Structural Assessment

Earthquake Engineering &Structural Dynamics, EarlyView.
ABSTRACT In current dynamic time history assessment protocols, ground motion recordings are mostly oriented along fixed sensor directions. Consequently, the orientation of the principal resultant of rupture energy, which may control the maximum structural demand, remains undefined, precluding consistent correlation with physically detrimental ...
Santiago Londono‐Lopez, Raffaele Cucuzza, Fabrizio Mollaioli, Giuseppe Carlo Marano, Marco Domaneschi   +4 more
wiley   +1 more source

Parametric Design and Experiment on Compression Performance of Hierarchical Origami Honeycomb Structures. [PDF]

Materials (Basel)
Lu X, Yang Y, Peng X.
europepmc   +1 more source

Optimization of Blasting‑Induced Roof Cutting Parameters in Key Stratum and Its Application in Gob‑Side Entry Retention Technology

Energy Science &Engineering, EarlyView.
This study addresses hard roof coal seam conditions by optimizing key stratum blasting‐cutting parameters through theoretical analysis, numerical simulation, and field tests. It proposes calculation methods for blast hole spacing and delay timing based on stress wave theory, controlling roadway deformation within 35 mm, thereby enhancing resource ...
Qiong Liu, Duanxiang Fu, Hongbin Li
wiley   +1 more source

Finite element analysis of progressive collapse resistance of a prefabricated RC frame structure with stud connection considering chloride corrosion. [PDF]

PLoS One
Gao Z, Zhang J.
europepmc   +1 more source

Research progress on flexible MXene‐based materials in advanced energy storage devices: From preparation strategies to device applications

FlexMat, EarlyView.
This review summarizes MXene synthesis and flexible electrode fabrication for FESDs, highlighting their potential owing to high conductivity and flexibility, and outlines future research directions. Abstract The rapid development of wearable and portable electronics has created demand for flexible energy storage systems (FESDs) that not only exhibit ...
Nanxi Miao, Ying Lu, Xing Gao, Lingzi Pan, Meng Gao, Chenxi Zhang, Ming Liu, Shizhong Wang, Zhongyu Weng, Huan Pang, Huijie Zhou   +10 more
wiley   +1 more source

The characteristics of plastic hinges in reinforced concrete

, 1974
openaire   +2 more sources