Electrospun amplified fiber optics [PDF]
, 2015 A lot of research is focused on all-optical signal processing, aiming to obtain effective alternatives to existing data transmission platforms. Amplification of light in fiber optics, such as in Erbium-doped fiber amplifiers, is especially important for ...
Amarasinghe D. +44 more
core +2 more sources
The Anti-Coincidence Detector for the GLAST Large Area Telescope [PDF]
, 2007 This paper describes the design, fabrication and testing of the Anti-Coincidence Detector (ACD) for the Gamma-ray Large Area Space Telescope (GLAST) Large Area Telescope (LAT).
Amato, M. J. +7 more
core +4 more sources
Optical fibers with interferometric path length stability by controlled heating for transmission of optical signals and as components in frequency standards [PDF]
, 2005 We present a simple method to stabilize the optical path length of an optical fiber to an accuracy of about 1/100 of the laser wavelength. We study the dynamic response of the path length to modulation of an electrically conductive heater layer of the ...
A. Peters +27 more
core +1 more source
A Novel Approach to Realize Plasmonic Sensors via Multimode Optical Waveguides: A Review
Sensors, 2023 In recent decades, the Surface Plasmon Resonance (SPR) phenomenon has been utilized as an underlying technique in a broad range of application fields. Herein, a new measuring strategy which harnesses the SPR technique in a way that is different from the ...
Francesco Arcadio +3 more
doaj +1 more source
Low-Cost Sensing with Plastic Optical Fibers—From Turbidity and Refractive Index to Chemical Sensing
Proceedings, 2019 This manuscript presents low-cost sensing systems for the monitoring of liquids, namely water and beverages quality assessment, with remote and in-site monitoring capabilities.
Filipa Sequeira +3 more
doaj +1 more source
Development of a low profile laser Doppler probe for monitoring perfusion at the patient – mattress interface [PDF]
, 1988 The clinical importance of pressure ulcers is reviewed confirming the need for continuous monitoring of skin blood perfusion at the patient – mattress interface.
A. CALZOLARI +9 more
core +260 more sources
Influence of design parameters on the performance of a refractive index sensor based on SPR in plastic optical fibers [PDF]
, 2015 We report a refractive-index sensor based on surface plasmon resonance in etched plastic optical-fibers.
Al-Qazwini, Yusser A. Taqi +4 more
core +1 more source
Overcoming Challenges in Large-Core SI-POF-Based System-Level Modeling and Simulation
Photonics, 2019 The application areas for plastic optical fibers such as in-building or aircraft networks usually have tight power budgets and require multiple passive components.
Dwight Richards +7 more
doaj +1 more source
Influence of Embedding Fiber Optical Sensors in CFRP Film Adhesive Joints on Bond Strength
Sensors, 2020 The increasing utilization of carbon fiber reinforced plastic (CFRP) in the aeronautical industry calls for a structural health monitoring (SHM) system for adhesively bonded CFRP joints. Optical glass fiber with inscribed fiber Bragg gratings (FBGs) is a
Neele Grundmann +4 more
doaj +1 more source
Iraqi Journal of Physics, 2019 Optical fiber chemical sensor based surface Plasmon resonance for sensing and measuring the refractive index and concentration for Acetic acid is designed and implemented during this work.
Ghufran Mohammed Jassam
doaj +1 more source