Solid state processing of titanium chips by an unconventional plastic working
Journal of Materials Research and Technology, 2021 The aim of this paper is to demonstrate how various titanium chips can be processed into solid bulk materials in the form of rods. In this work, an alternative technology for recycling chips without re-melting is presented.
Krzysztof Topolski, Paweł Ostachowski
doaj +3 more sources
The Experimental and Numerical Research for Plastic Working of Nickel Matrix Composite Coatings [PDF]
Materials, 2020 Wioletta Kuśmierska-Matyszczak +2 more
exaly +2 more sources
Full Endoscopic Posterolateral Transarticular Lumbar Interbody Fusion Using Transparent Plastic Working Tubes: Technical Note and Preliminary Clinical Results [PDF]
Frontiers in Surgery, 2022 Xudong Yao, Yao Xudong
exaly +2 more sources
Examination of the Force Parameters in Drawing Process of CuZn39Pb3 Cast Rod using Selected Lubricants [PDF]
Archives of Foundry Engineering, 2023 The paper presents the results of research on the wire drawing process of wire brass using different deformation degree and using selected lubricants of different viscosity.
Michał Jabłoński
doaj +1 more source
Inhomogeneity of microstructure and mechanical propertiesof 7050-T7651 aluminum alloy thick plate
Journal of Aeronautical Materials, 2023 The differences in the microstructure, grain orientation, texture type, aging nano precipitate phase distribution and mechanical properties of 160 mm 7050-T7651 aluminum alloy extra-thick plate at different thickness positions were studied by means of ...
WANG Jingtao +5 more
doaj +1 more source
Effect of solution treatment on microstructure and properties of Al-Zn-Mg-Cu alloy
Journal of Aeronautical Materials, 2023 The hot-rolled Al-Zn-Mg-Cu system aluminum alloy was treated with single-stage solution，low temperature-long term & high temperature-short term and low temperature-short term & high temperature-long term，double-stage solution quenching systems.
WANG Jingtao +7 more
doaj +1 more source
Assessment of the Tribological Performance of Bio-Based Lubricants Using Analysis of Variance
Advances in Mechanical and Materials Engineering, 2023 The purpose of this article is to determine the coefficient of friction of the DC04 steel sheet using a specially designed flat die strip drawing test.
Marek Szewczyk, Krzysztof Szwajka
doaj +1 more source
Finite element analyses of female-thread forming process and loosening proof of self-tapping screw
Nihon Kikai Gakkai ronbunshu, 2023 Tapping screw fabricates the female thread due to plastic deformation during screw rotation. Since the tapping screw skips the preliminary fabrication of female thread, it is widely used for the tightening in the fields of such as electric parts and car ...
Yujin TOMITA +5 more
doaj +1 more source
Process parameters optimization for minimizing risk of crack and forging energy in cold forging
Nihon Kikai Gakkai ronbunshu, 2021 Cold forging is a typical manufacturing technology to produce various mechanical components with high productivity. Various process parameters such as punch velocity and forging loads are adjusted for successful forging.
Shimon KADOYA +3 more
doaj +1 more source
Forces and Plastic Work in Cutting
CIRP Annals, 1983 Prolific considerations in C.I.R.P. give rise to a further step in the development of a plastic cutting model. Basically two different primary shear zone geometries are assumed: with one and with two shear planes respectively. For both geometries two energetically different approaches are developed.
Dautzenberg, J.H. +2 more
openaire +4 more sources