Results 41 to 50 of about 39,492 (350)

Ionic Liquid-Nanostructured Poly(Methyl Methacrylate)

open access: yesNanomaterials, 2019
Here, ionic liquids (ILs) based on imidazolium and ammonium cations were used as modifying agents for poly(methyl methacrylate) (PMMA) by extrusion. The effects of the chemical nature of the cation and/or counter anion on the resulting properties of IL ...
Clarice Fedosse Zornio   +3 more
doaj   +1 more source

Broadband Continuous Spectral Control of a Single Wavelength Polymer-Based Solid-State Random Laser [PDF]

open access: yesarXiv, 2023
We demonstrate temperature-controlled spectral tunability of a partially-pumped single-wavelength random laser in a solid-state random laser based on DCM (4-dicyanomethylene-2-methyl-6-(p-dimethylaminostyryl)-4H-pyran) doped PMMA (polymethyl methacrylate) dye.
arxiv  

Thermal and mechanical studies of nanochitosan incorporated polymethyl methacrylate-based composite electrolytes

open access: yesJournal of Engineering and Applied Science, 2022
The composite solid polymer electrolytes based on Polymethyl methacrylate–Lithium triflate with nanochitosan as inert nanofiller were prepared by membrane hot-press method. Nanochitosan was synthesized from shrimp shell. The obtained polymer membrane was
P. M. Shyly   +2 more
doaj   +1 more source

Tunable Ultraviolet Vertically-emitting Organic Laser [PDF]

open access: yes, 2011
A solid-state organic thin-film laser with intracavity frequency doubling is reported. Tunable ultraviolet emission from 309 to 322 nm is achieved from a vertical external cavity surface-emitting organic laser, with 2 % efficiency (1 $\mu$J at 315 nm). The laser comprises a polymethyl(methacrylate) layer doped with Rhodamine 640, spun-cast onto a plane
arxiv   +1 more source

Droplets on liquids and their long way into equilibrium [PDF]

open access: yes, 2012
The morphological paths towards equilibrium droplets during the late stages of the dewetting process of a liquid film from a liquid substrate is investigated experimentally and theoretically.
Bommer, Stefan   +4 more
core   +3 more sources

High Mobility Ambipolar MoS2 Field-Effect Transistors: Substrate and Dielectric Effects [PDF]

open access: yes, 2012
We fabricate MoS2 field effect transistors on both SiO2 and polymethyl methacrylate (PMMA) dielectrics and measure charge carrier mobility in a four-probe configuration. For multilayer MoS2 on SiO2, the mobility is 30-60 cm2/Vs, relatively independent of thickness (15-90 nm), and most devices exhibit unipolar n-type behavior.
arxiv   +1 more source

Single photon emission from ZnO nanoparticles [PDF]

open access: yes, 2014
Room temperature single photon emitters are very important resources for photonics and emerging quantum technologies. In this work we study single photon emission from defect centers in 20 nm zinc oxide (ZnO) nanoparticles. The emitters exhibit bright broadband fluorescence in the red spectral range centered at 640 nm with polarized excitation and ...
arxiv   +1 more source

Effect of Phosphate Group Addition on the Properties of Denture Base Resins [PDF]

open access: yes, 2008
Statement of problem Acrylic resins are prone to microbial adherence, especially by Candida albicans. Surface-charged resins alter the ionic interaction between the denture resin and Candida hyphae, and these resins are being developed as a means to ...
Berzins, David W.   +6 more
core   +2 more sources

Enhanced analysis of gating latency in 0.35T MR‐linac through innovative time synchronization of a motion phantom and plastic scintillation detector

open access: yesJournal of Applied Clinical Medical Physics, EarlyView.
Abstract Purpose This study aims to evaluate how different gantry angles, breathing rates (BPM), cine image speeds, and tracking algorithms affect beam on/off latency and the subsequent impact on target dose for a 0.35T MR‐Linac with a 6 MV FFF beam.
Mateb Al Khalifa   +4 more
wiley   +1 more source

Influence of emulgator nature on dispersity and stability of artificial polymer suspensions based on polycarbonate and polymethyl methacrylate

open access: yesТонкие химические технологии, 2022
Objectives. To create stable artificial polymer suspensions with a positive charge of particles based on polycarbonate and polymethyl methacrylate using cationic surfactants and organosilicon surfactants.Methods.
A. N. Stuzhuk   +3 more
doaj   +1 more source

Home - About - Disclaimer - Privacy