Results 161 to 170 of about 10,132 (279)

Well-defined and “complete” Al-cocatalysts for Olefin Polymerization, 1: Synthesis and Reactivity Studies

open access: yes, 2023
Roberta Cipullo   +8 more
core  

Polyolefin composite with enhanced processing properties

open access: yes, 2015
Polyolefinický kompozit se zlepšenými zpracovatelskými vlastnostmi obsahuje vedle základní polymerní složky tvořené polyolefinem přídavek multifunkčního aluminosilikátového aditiva se synergickými účinky taveninu ztužujícího plniva a nukleačního činidla ...
Zatloukal, Martin   +6 more
core  

Cosolvent‐Enhanced Dissolution of Long‐Chain Polyamides: Toward Room‐Temperature Material Recycling of Sustainable Composites

open access: yesChemSusChem, Volume 19, Issue 13, 14 July 2026.
Long‐chain polyamides (PAs) such as bio‐derived PA11 and conventional PA12 are difficult to dissolve at room temperature, hindering facile recycling by dissolution‐based methods. This work shows that adding a weak H‐bonding cosolvent to formic acid can rapidly dissolve long‐chain PAs at room temperature by balancing H‐bonding and dispersive ...
Jonathon Tanks, Kenji Tamura
wiley   +1 more source

Interaction of chlorinated polyolefin (CPO) with components of thermoplastic polyolefin (TPO)

open access: yes, 2004
The surface and interface (interphase) of CPO-coated TPO substrate were also characterized. Solvent wiping of the TPO substrates increased the roughness of the TPO surface, while CPO-solution-coating followed by baking had a much larger effect on the ...
Ma, Yuechun
core  

Behavior of a Novel Cyclic Olefin‐Based Hot‐Melt Adhesive in CFRP Adhesive Joints Compared to Conventional Epoxy‐Based Structural Adhesives

open access: yesPolymer Composites, Volume 47, Issue 13, Page 11783-11797, 10 July 2026.
Rate‐dependent performance of composite adhesive joints using thermoset and thermoplastic adhesives, in terms of toughness and fatigue behaviour. ABSTRACT A recently developed hot‐melt adhesive (HMA) based on cyclic olefin chemistry, supplied as a transparent, non‐tacky thermoplastic film with a distinctive polymer microstructure, was evaluated in this
Hossein Malekinejad   +3 more
wiley   +1 more source

High Density Polyethylene/Ground Tire Rubber Composites Compatibilized by Dicumyl Peroxide

open access: yesJournal of Applied Polymer Science, Volume 143, Issue 25, July 5, 2026.
ABSTRACT In this study, the thermal behavior of dicumyl peroxide (DCP) was first evaluated by differential scanning calorimetry (DSC) and thermogravimetric analysis (TGA), which confirmed a peak decomposition temperature around 172°C, highlighting its incompatibility with standard melt‐mixing techniques for most polyolefins. To overcome this limitation,
Hibal Ahmad, Denis Rodrigue
wiley   +1 more source

Batteries From Reused, Recycled, and Surplus Materials

open access: yesAdvanced Sustainable Systems, Volume 10, Issue 7, July 2026.
Batteries can become more circular by combining reuse, direct recycling, metallurgical recovery, and material sourcing from industrial surplus streams. This Review highlights how recycled and waste‐derived metals, carbons, polymers, electrolytes, and active materials can be reintegrated into current and emerging batteries, while emphasizing design ...
Jing Yu   +16 more
wiley   +1 more source

Home - About - Disclaimer - Privacy