Results 221 to 230 of about 28,551 (308)
HEAT-TREATMENT OF POLYPROPYLENE FIBERS
Sen'i Gakkaishi, 1962 Kuribayashi, Shunsuke, Nakai, Akiyoshi
openaire +2 more sources
Movement Disorders, EarlyView.Abstract Background Despite widespread cortical involvement in Lewy body diseases, conventional gray matter magnetic resonance imaging (MRI) shows limited sensitivity. Diffusion‐weighted MRI‐derived microstructural measures have shown utility in Alzheimer's disease, but their application across the Lewy body disease spectrum remains limited ...
Angeliki Zarkali +9 more
wiley +1 more source
Synergistic Improvement of Strength Characteristics in Recycled Aggregates Using Nano-Clay and Polypropylene Fiber. [PDF]
Polymers (Basel)Zhao T +5 more
europepmc +1 more source
STUDIES ON DYEING OF POLYPROPYLENE FIBERS
Sen'i Gakkaishi, 1962 Teramura, Kazuhiro +2 more
openaire +2 more sources
Polymer Composites, EarlyView.Masterbatch‐Assisted Fabrication of Polylactic Acid/Reduced Graphene Oxide Nanocomposites. ABSTRACT Polylactic acid (PLA) is a promising bio‐based polymer; nonetheless, its extensive application is still limited by poor fracture toughness, low thermal stability, and strong susceptibility to degradation induced by ultraviolet (UV) radiation.
Maria Giovanna Pastore Carbone +4 more
wiley +1 more source
HEAT-TREATMENT OF POLYPROPYLENE FIBERS
Sen'i Gakkaishi, 1963 Kuribayashi, Shunsuke +2 more
openaire +2 more sources
Polymer Composites, EarlyView.Preparation of lightweight composite panels from multilayer beverage carton waste. ABSTRACT Beverage carton waste, a multi‐layer composite of cardboard, polymer, and aluminum, presents significant recycling challenges for conventional recovery technologies. This work presents a manufacturing process‐oriented method that allows shredded beverage cartons
Csenge Tóth +2 more
wiley +1 more source
Optimization Design of Mix Proportion for Fly Ash-Silica Fume-Basalt Fiber-Polypropylene Fiber Concrete under Steam Curing Condition. [PDF]
Materials (Basel)Li Z, Li G, Wang C, Li W, Zheng H.
europepmc +1 more source
Thermoplastic‐Resin Transfer Molding Technology: Development and Challenges Toward Industrialization
Polymer Composites, EarlyView.Illustration of the key aspects involved in the manufacture of thermoplastic composites by T‐RTM highlighting the relationships between raw materials, resin mixing strategies, polymerization parameters, and processing equipment ranging from laboratory to industrial scale. ABSTRACT Driven by increasingly stringent international environmental regulations,
Filipe P. Martins +4 more
wiley +1 more source
Polymer Composites, EarlyView.(top) fabrication and multi‐scale characterizations of self‐reinforced polyethylene composites (PE‐SRCs); (bottom) effects of cooling rates on mechanical properties and crystal morphologies of PE‐SRCs. ABSTRACT This study investigates cooling rate effects on self‐reinforced polyethylene composites (PE‐SRCs), focusing on macroscopic thermal and ...
Yelin Ni +7 more
wiley +1 more source