Results 61 to 70 of about 13,508 (243)
CHARACTERIZATION OF POLYPYRROLE
Using β, β' dimethylpyrrole polymers to reduce the structural disorder it has been possible to interpret the results of electron diffraction data and to propose an idealized structure for neutral polypyrrole. XPS data have been used to define some of the deviations from this ideal structure that are seen in actual films and the origin of some of these ...
Street, G. +6 more
openaire +2 more sources
Multidimensional laser‐induced graphene (LIG) spanning from 0D to 3D architectures is comprehensively reviewed for multifunctional biomedical platforms, including biosensing, theranostics, and bioactive interface applications, which highlights its potentials for point‐of‐care diagnostics, wearable health monitoring, smart drug delivery, and tissue ...
Li Zhang +3 more
wiley +1 more source
A closed‐loop “Concentrate‐Destroy” strategy is presented for completely eliminating short‐chain and emerging PFAS, in which the new 3D PPy@P‐CF is used for efficiently concentrating PFAS and Cu2+‐mediated photodegradation is applied for the completely destroying PFAS in the sorbent regeneration eluent.
Hao Yu +5 more
wiley +1 more source
A method of producing extremely adhesive polypyrrole film on Titanium (Ti) substrate was investigated. The Ti substrate was chemically pretreated and then modified by polydopamine (PDA), the polypyrrole film synthesized by electrochemical method on the ...
Tan Jilin, Zhang Zhong, Ge Dongtao
doaj +1 more source
Continuous wet‐spinning of PANI with TeNWs yields a multifunctional microfiber. Oriented TeNWs impose chain alignment and enhance π‐electron delocalization, boosting the Seebeck coefficient to 59.9 µV K−1 for passive temperature sensing (1 K detection limit), while achieving high pH sensitivity (59.25 mV pH−1) and rapid NH3 response (0.96 s).
Dongmei Xie +10 more
wiley +1 more source
Current Collector Engineering for New Efficient Bioresorbable Sodium‐Ion Batteries
A bioresorbable Na‐ion battery is proposed with Mo or Mg thin‐film current collectors for temporary implants. Mo‐based batteries exhibit superior electrochemical performance and stable cycling compared with Mg counterparts. XPS was used to investigate the Mo/Mg surface oxidation.
Bincy Lathakumary Vijayan +15 more
wiley +1 more source
Bamboo‐like nitrogen‐doped carbon fibers (BNCFs) were synthesized via a vapor‐liquid‐solid catalytic growth method and further integrated with polyaniline to fabricate a freestanding BNCFs/S/PANI cathode. The PANI coating and BNCFs framework synergistically establish an interconnected conductive network with abundant nitrogen‐active sites, thereby ...
Jie Yang +5 more
wiley +1 more source
This overview summarizes versatile 2D layered materials for AZIB anodes, cathodes, separators and electrolytes, illustrating their dendrite/side reaction suppression mechanisms, and analyzes existing hurdles to propose scalable commercial research outlooks.
Shuge Dai +7 more
wiley +1 more source
Stability of TiO2–Polypyrrole Heterojunctions for Photoelectrochemical Water Oxidation
TiO2 composites with polypyrrole have gained attention for various applications; however, some reported results on the suitability of this heterojunction for photoelectrochemical water oxidation do not agree.
Jhon Puerres +2 more
doaj +1 more source
Physico-Chemical Properties of Nanoparticles Functionalized by Polypyrrole [PDF]
Мagnetite nanoparticles coated with polypyrrole have been synthesized. Nanocomposite powder has been investigated by FTIR, XRD, SEM, magnetometry, conductivity measurements.
Yu.A. Mirgorod +2 more
doaj

