Results 231 to 240 of about 4,349 (291)

Unveiling the impact of polystyrene nanoplastics on tea seedlings: uptake, translocation, and oxidative stress-mediated alterations. [PDF]

J Sci Food Agric
Shen T, Liu F, Zhang R, Yang T, Zhang P, Zhou X, Hua R, Zong J, Jiao W.   +8 more
europepmc   +1 more source

Growth phase is an important, species-specific determinant of yeast adhesion to abiotic surfaces. [PDF]

Sci Rep
Plocek V, Maršíková J, Irianto VS, Váchová L, Palková Z.   +4 more
europepmc   +1 more source

Some of the next articles are maybe not open access.

Related searches:

A Polystyrene−Oligothiophene−Polystyrene Triblock Copolymer

Journal of the American Chemical Society, 1998
A well-defined triblock copolymer is synthesized by using a strategy in which the a-coupling of 11 thiophene rings of the middle block and the monodispersity (d.p. = 30 and 1.1) of the two polystyrene outer blocks is ensured. Monofunctional polystyrene is modified with an a-terthiophene unit and two of these units are coupled in a double Stetter ...
Hempenius, M., Langeveld-Voss, B., Haare, J., Janssen, R., Sheiko, S., Spatz, J., Möller, M., Meijer, E.   +7 more
openaire   +3 more sources

Thermal degradation of alkyne-containing polystyrenes

Journal of Analytical and Applied Pyrolysis, 2003
The synthesis and thermal behavior of several alkyne-containing polystyrenes was studied. The introduction of the alkynyl group was performed by coupling reaction of poly(p-bromostyrene) with alkynes using palladium/copper catalyst.
Fabio Bertini
exaly   +1 more source

Polystyrenes

2016
exaly   +2 more sources

Synthesis and evaluation of polystyrene–polybutadiene–polystyrene–dodecafluoroheptyl methacrylate/polystyrene–polybutadiene–polystyrene hybrid antifouling coating

Journal of Colloid and Interface Science, 2014
Copolymers SBS-DFHMA and mesoporous silica SBA-15 were respectively synthesized and SBS-DFHMA were mixed with SBA-15 to prepared hybrid antifouling coatings by a spin-coater. By measuring the surface water contact angle and the attachment of Pseudomonas fluorescens, Chlorella and Diatoms, the antifouling properties of coatings were evaluated.
Jiang, Li, Guoqing, Wang, Chunhua, Ding, Hong, Jiang, Peiqing, Wang   +4 more
openaire   +2 more sources

Immiscibility in polystyrene/sulfonated polystyrene blends

Polymer, 1995
Abstract Miscibility in the binary system of deuterated polystyrene and lightly sulfonated polystyrene has been investigated. Small-angle neutron scattering was used to evaluate the physical state of deuterated polystyrene/polystyrene—1.67% sulfonic acid blends over a wide composition range.
N.C.Beck Tan, X. Liu, R.M. Briber, D.G. Peiffer   +3 more
openaire   +1 more source

Dielectric properties of polystyrene and polystyrene-chloranil

Thin Solid Films, 1980
Abstract Dielectric permittivities and losses were measured above room temperature in the frequency range 102–105 Hz for undoped and chloranil- (Chl-) doped polystyrene (PS) films (thickness about 15 μm) with progressively increasing Chl concentrations.
Y.K. Kulshrestha, A.P. Srivastava
openaire   +1 more source

Photodegradation of polystyrene and polystyrene containing benzophenone

Polymer Photochemistry, 1983
Abstract The photodegradation of polystyrene has been studied by electron spin resonance, infra-red absorption, viscosity and gel fraction measurements. Irradiations with light from a medium pressure mercury lamp to polystyrene film at 45°C in vacuum, gave rise to the polystyryl radical.
Ayako Torikai, Tetsuya Takeuchi, Kenji Fueki   +2 more
openaire   +1 more source

Polystyrene

2009
Abstract Major Applications One of the most widely used plastics, having applications in industries of packaging, appliances, construction, automobiles, electronics, furniture, toys, house wares, and luggage (1–3). Properties of Special Interest Crystal clear thermoplastic, hard, rigid, free of odor and taste, ease of heat fabrication ...
  +4 more sources