Results 91 to 100 of about 100,855 (336)
Two‐Dimensional Materials as a Multiproperty Sensing Platform
Advanced Functional Materials, EarlyView.Various sensing modalities enabled and/or enhanced by two‐dimensional (2D) materials are reviewed. The domains considered for sensing include: 1) optoelectronics, 2) quantum defects, 3) scanning probe microscopy, 4) nanomechanics, and 5) bio‐ and chemosensing.
Dipankar Jana +11 more
wiley +1 more source
Film breakers prevent migration of aqueous potassium hydroxide in fuel cells [PDF]
, 1970 Electrolyte film breakers made from polytetrafluoroethylene are installed in the reactant and water vapor removal outlets of each cell and sealed by elastomers.
Hess, P. D.
core +1 more source
Advanced Functional Materials, EarlyView.An adapted processing for solvent‐free argyrodite solid electrolyte films based on insights into degradation mechanisms of the widely used binder polytetrafluoroethylene is presented. By adapting the dry film processing, long‐term cycling in Si||NMC pouch cells is demonstrated over more than 1000 cycles with a capacity retention of more than 80%, and ...
Maria Rosner +10 more
wiley +1 more source
Nonlinear phononic crystals based on chains of disks alternating with toroidal structures [PDF]
, 2011 We study experimentally the acoustic response of a load-bearing, phononic crystal composed of alternating steel disks, and polytetrafluoroethylene o-rings under precompression.
Brown, M. +3 more
core +2 more sources
Advanced Functional Materials, EarlyView.A dual‐binder dry‐processed electrode (DB‐DPE) combining PTFE and PVDF with a nanostructured Al current collector (NSA) forms a mechanically interlocked interface that significantly improves adhesion and reduces interfacial resistance. With an active material content as high as 96 wt.%, the NSA‐based DB‐DPE enables high‐mass‐loading operation (12.5 mAh
Seok Yun Kim +4 more
wiley +1 more source
Advanced Functional Materials, EarlyView.Dry electrode technology revolutionizes battery manufacturing by eliminating toxic solvents and energy‐intensive drying. This work details two promising techniques: dry spray deposition and polymer fibrillation. How their unique solvent‐free bonding mechanisms create uniform microstructures for thicker, denser electrodes, boosting energy density and ...
Yuhao Liang +7 more
wiley +1 more source
Superconductivity in WO2.6F0.4 synthesized by reaction of WO3 with Teflon
, 2011 WO3-xFx (x < 0.45) perovskite-like oxyfluorides were prepared by a chemically reducing fluorination route using the polymer polytetrafluoroethylene (Teflon). The symmetry of the crystal structures of WO3-xFx changes from monoclinic to tetragonal to cubic
Cava, R. J. +2 more
core +1 more source
Advanced Functional Materials, EarlyView.Controlled laser‐drilling of embedded HfO2 membranes creates three layer nanopores with Gaussian‐shaped cavities sculptured in the supporting layers. These embedded solid‐state nanopores slow DNA translocation by 12‐fold compared to SiNx pores, enabling high‐resolution, label‐free detection of short DNAs, RNAs, and proteins.
Jostine Joby +4 more
wiley +1 more source
Advanced Functional Materials, EarlyView.Fe─NC porous oxygen reduction electrocatalysts are prepared employing a 2,4,6‐Triaminopyrimidine‐based porous organic polymer, a Mg2+ Lewis acid, and a low‐temperature cation exchange protocol. Using the polymer precursor achieves high pyrolysis yields and results in atomically dispersed FeNx sites. The resulting catalysts feature hierarchical porosity
Eliot Petitdemange +11 more
wiley +1 more source
Advanced Functional Materials, EarlyView.A FeN4─O/Clu@NC‐0.1Ac catalyst containing atomically‐dispersed FeN4─O sites (medium‐spin Fe2+) and Fe clusters delivered a half‐wave potential of 0.89 V for ORR and an overpotential of 330 mV at 10 mA cm−2 for OER in 0.1 m KOH. When the catalyst was used in a rechargeable Zn–air battery, a power density of 284.5 mW cm−2 was achieved with excellent ...
Yongfang Zhou +8 more
wiley +1 more source