Results 71 to 80 of about 716,517 (294)
Designing heterogeneous porous tissue scaffolds for additive manufacturing processes [PDF]
, 2013 A novel tissue scaffold design technique has been proposed with controllable heterogeneous architecture design suitable for additive manufacturing processes.
Khoda, AKM Bashirul +4 more
core +1 more source
Advanced Engineering Materials, EarlyView.High‐temperature interactions between low‐sulfur Al‐killed Mn–B steel and MgO–C refractories (0 and 50 wt% recyclates) are studied via finger immersion tests (1600 °C). Surface‐active elements influence infiltration. MgO/CaS layer forms, along with spinel and calcium silicate.
Matheus Roberto Bellé +5 more
wiley +1 more source
Preparación y propiedades de materiales cerámicos bioinertes en el sistema Al2O3-TiO2-SiO2
Boletín de la Sociedad Española de Cerámica y Vidrio, 1998 Very fine and sinterable ceramic powders (100-600 nm) in the system Al2O3-TiO2-SiO2 were obtained by the method of cohydrolisis from organo-metallic precursors.
Boccaccini, A. R. +4 more
doaj
The effect of contact torques on porosity of cohesive powders
, 2004 The porosity of uniaxially compacted cohesive powders depends on the applied stress (including gravity). The case, where these stresses are weak, is considered.
Bartels, Guido +4 more
core +1 more source
Advanced Engineering Materials, EarlyView.The thermal diffusivity of MgO‐C refractories is highly sensitive to sample preparation and processing procedures. In this article, the effects of coking sequence, machining conditions, structural inhomogeneity, and graphite coating application on measurements using laser flash apparatus are systematically investigated.
Luyao Pan +4 more
wiley +1 more source
Cailiao gongcheng, 2017 Nickel-based bond coating and composite functional coating were sprayed on leaf blade steel material FV520B successively by using air plasma spraying system.
DU Ji-yu +4 more
doaj +1 more source
Porous dust grains in debris disks [PDF]
, 2013 When modeling the density and grain size distribution in debris disks, the minimum particle size is often significantly larger than the corresponding blowout size.
Kirchschlager, Florian, Wolf, Sebastian
core +1 more source
Advanced Engineering Materials, EarlyView.This study investigates the tribological response of 60NiTi alloy under dry, water‐lubricated and high‐temperature conditions. The alloy exhibits decreasing wear volume and friction with increasing temperature due to the formation of protective oxide layers. The work clarifies dominant wear mechanisms and demonstrates the suitability of 60NiTi for high‐
Anthony Onyebuchi Okoani +2 more
wiley +1 more source
Dealloying of Platinum-Aluminum Thin Films Part I. Dynamics of Pattern Formation
, 2011 Applying focused ion beam (FIB) nanotomography and Rutherford backscattering spectroscopy (RBS) to dealloyed platinum-aluminum thin films an in-depth analysis of the dominating physical mechanisms of porosity formation during the dealloying process is ...
Felix Rechberger +11 more
core +1 more source
Advanced Engineering Materials, EarlyView.Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source