Results 11 to 20 of about 33,503 (264)
Tribology Online, 2020 The use of porous facing/layer in fluid film bearings offers some unique advantages such as self-lubricating properties (acting as lubricant reservoir), compactness, economical over conventional bearing etc.
Vivek Kumar +3 more
doaj +1 more source
Lubrication Characteristics of Porous Inclined Stepped Composite Bearings with Couple Stress Fluids
Tribology Online, 2013 This paper presents the theoretical study of porous inclined stepped composite bearings with couple stress fluids. The generalized Reynolds type equation is derived for porous inclined stepped composite bearings with couple stress fluids. The closed form
Siddangouda Apparao +2 more
doaj +1 more source
Dynamic Performance of Partially Orifice Porous Aerostatic Thrust Bearing
Micromachines, 2021 The aerostatic thrust bearing’s performance under vibration brings certain changes in stiffness and stability, especially in the range of 100 to 10,000 Hz, and it is accompanied by significant increase in fluctuations due to the changes in frequency, and
Muhammad Punhal Sahto +4 more
doaj +1 more source
Tribology Online, 2022 In this paper, an investigation has been made to study the dynamic characteristics of porous inclined slider bearing with rough surface lubricated with micropolar fluid lubricant.
N.B. Naduvinamani, Ashwini Angadi
doaj +1 more source
Pressure Distribution in a Porous Squeeze Film Bearing Lubricated with a Herschel-Bulkley Fluid
International Journal of Applied Mechanics and Engineering, 2016 The influence of a wall porosity on the pressure distribution in a curvilinear squeeze film bearing lubricated with a lubricant being a viscoplastic fluid of a Herschel-Bulkley type is considered.
A. Walicka, P. Jurczak
doaj +1 more source
FEEDING SYSTEM OF AEROSTATIC BEARINGS WITH POROUS MEDIA
Proceedings of the JFPS International Symposium on Fluid Power, 2005 In porous resistances, Darcy’s law provides a good approximation of mass flow rate when the differences between upstream and downstream pressures are sufficiently small. In this range, the mass flow rates are proportional to the porous resistance’s permeability.
BELFORTE, GUIDO +3 more
openaire +5 more sources
Advanced Engineering Research, 2014 The asymptotic solution to the problem on the hydrodynamic calculation of the porous double - layer r a dial finite length bearing is provided on the eccentricity ratio levels.
Akhmat Chokayevich Erkenov +3 more
doaj +1 more source
Design model of thrust bearing with porous coating on the way surface
Advanced Engineering Research, 2017 Introduction. The development of the design model of a thrust sliding bearing with a two-layer porous coating on the way surface running on an electrically conductive lubricant is described.
Murman A. Mukutadze +2 more
doaj +1 more source
Novel Numerical Analysis of a Self-Circulating Bearing
Applied SciencesA novel closed-form solution representing the fluid motion within a porous bushing was created to develop a recently patented bearing configuration with a self-contained lubrication system.
Elizabeth J. Clifford +1 more
doaj +1 more source
Lubrication characteristics of a textured porous sliding bearing
Advances in Mechanical Engineering, 2015 This study investigates the lubrication characteristics of a textured bearing sliding on a porous layer. To properly implement the porous layer effect in the bearing, the Brinkman-extended-Darcy model is employed, which results in a modified Reynolds ...
Sooyoung Lee +5 more
doaj +1 more source