Results 231 to 240 of about 1,402,001 (278)
Some of the next articles are maybe not open access.
Constrained Clustering via Post-processing
2020Constrained clustering has received much attention since its inception as the ability to add weak supervision into clustering has many uses. Most existing work is algorithm-specific, limited to simple together and apart constraints and does not attempt to satisfy all constraints.
Nghiem, Nguyen-Viet-Dung +3 more
openaire +2 more sources
Interactive Disparity Map Post-processing
2012 Second International Conference on 3D Imaging, Modeling, Processing, Visualization & Transmission, 2012Disparity estimation has been investigated for decades. Fully automatic methods have problems in texture-less regions, around object boundaries and in occlusions regions. In this paper, we exploit user input to address these problematic areas interactively.
Lin, Caizhang +3 more
openaire +2 more sources
1989
The major goal of this chapter is to discuss various problems involved in radar image analysis. Although the information contained in analogue radar imagery will satisfy the needs of a majority of users, more sophisticated analysis of the data may be required for specific tasks.
Daniel R. Nüesch, Erich H. Meier
openaire +1 more source
The major goal of this chapter is to discuss various problems involved in radar image analysis. Although the information contained in analogue radar imagery will satisfy the needs of a majority of users, more sophisticated analysis of the data may be required for specific tasks.
Daniel R. Nüesch, Erich H. Meier
openaire +1 more source
1992
Once a design has been generated by DMoct, it has to be verified and tested before the final data for fabrication can be created and shipped to the manufacturer. Simulation data must be extracted from a structural or physical representation, design rule checking (DRC) performed, CIF (Caltech Intermediate Form) layer representation generated, and the ...
Marcus Thaler +2 more
openaire +1 more source
Once a design has been generated by DMoct, it has to be verified and tested before the final data for fabrication can be created and shipped to the manufacturer. Simulation data must be extracted from a structural or physical representation, design rule checking (DRC) performed, CIF (Caltech Intermediate Form) layer representation generated, and the ...
Marcus Thaler +2 more
openaire +1 more source
Automatisiertes Post-Processing
VDI-ZForschende am Fraunhofer-Institut für Produktionsanlagen und Konstruktionstechnik IPK entwickeln neue Technologien, um die Wirtschaftlichkeit der Endbearbeitung additiv gefertigter Metallbauteile zu steigern.
Eckart Uhlmann +3 more
openaire +1 more source
Introduction to post-processing techniques
European Journal of Radiology, 2008The quality of data measured in in vivo MR spectroscopy is often insufficient due to a number of limitations such as low concentrations of observed metabolites and restricted measurement time resulting in a low signal-to-noise ratio. However, there are a variety of methods called post-processing techniques which allow the enhancement of the measured ...
openaire +2 more sources
Afterall: A Journal of Art, Context and Enquiry, 1999
Julian Heynen, Fiona Elliott
openaire +1 more source
Julian Heynen, Fiona Elliott
openaire +1 more source