Effect of temperature and pre-annealing on the potential-induced degradation of silicon heterojunction photovoltaic modules [PDF]
, 2022 We investigate the effect of temperature and pre-annealing on the potential-induced degradation (PID) of silicon heterojunction (SHJ) photovoltaic (PV) modules.
Masuda, Atsushi +3 more
core +1 more source
Second-stage potential-induced degradation of n-type front-emitter crystalline silicon photovoltaic modules and its recovery [PDF]
, 2023 We investigate the second-stage potential-induced degradation (PID) of n-type front-emitter (n-FE) crystalline silicon (c-Si) photovoltaic (PV) modules. The PID of n-FE c-Si PV modules is known to occur in three stages under negative bias stress.
Masuda, Atsushi +7 more
core +1 more source
Effects of passivation configuration and emitter surface doping concentration on polarization-type potential-induced degradation in n-type crystalline-silicon photovoltaic modules [PDF]
, 2021 System voltages can cause significant degradation in photovoltaic modules. Polarization-type potential-induced degradation (PID) is accompanied by decreases in the short-circuit current density and the open-circuit voltage.
Masuda, Atsushi +5 more
core +1 more source
Influence of emitter position of silicon heterojunction photovoltaic solar cell modules on their potential-induced degradation behaviors [PDF]
, 2020 Potential-induced degradation (PID)-test results of modules fabricated from the rear- and front-emitter silicon heterojunction (SHJ) solar cells were compared to clarify the influence of the emitter position of SHJ photovoltaic (PV) cell modules on their
Masuda, Atsushi +4 more
core +1 more source
Characterization of Potential-Induced Degradation and Recovery in CIGS Solar Cells
Energies, 2021 The potential-induced degradation (PID) mechanism in Cu(In,Ga)(Se,S)2 (CIGS) thin-film solar cells, which are alternative energy sources with a high efficiency (>23%) and upscaling possibilities, remains unclear. Therefore, the cause of PID in CIGS solar
Solhee Lee +8 more
doaj +1 more source
Journal of Energy in Southern Africa, 2022 Potential induced degradation (PID) is a defect that has a severe effect on the performance of photovoltaic (PV) modules in field conditions. It is caused by leakage currents and the accumulation of sodium ions (Na+) between the anti-reflective coating ...
I.M. Kwembur +3 more
doaj +1 more source
Energies, 2019 Potential induced degradation (PID) leads to power degradation, and reduces durability and reliability of solar modules. However, this problem has not been thoroughly solved so far.
Jingsheng Huang +3 more
doaj +1 more source
Energies, 2021 Many photovoltaic (PV) parks suffer from a decrement in their generated power capability due to a phenomenon called potential induced degradation (PID).
Alex Mirtchev +3 more
doaj +1 more source
Reduction in the short-circuit current density of silicon heterojunction photovoltaic modules subjected to potential-induced degradation tests [PDF]
, 2016 This letter deals with the potential-induced degradation (PID) of silicon heterojunction(SHJ) photovoltaic (PV) modules. After rapid indoor PID tests applying a voltage of −1000 V at 85 ◦C, the modules exhibited a significant reduction in short-circuit ...
Masuda, Atsushi +3 more
core +1 more source
Performance Comparison of Electrical Indicators for Detection of PID in PV panels
Revista UIS Ingenierías, 2022 Potential-induced degradation (PID) in photovoltaic (PV) solar panels occurs due to the operation in strings that are part of large installations, and under determinate voltage and environmental operating conditions, especially humidity and temperature.
Jhoan Sebastian Parra-Quiroga +3 more
doaj +1 more source