Results 191 to 200 of about 5,208,445 (245)

Copper Electroplated TPMS Polymer Lattices for Lightweight Absorption Dominant Electromagnetic Interference Shielding

open access: yesAdvanced Materials Technologies, EarlyView.
Copper electroplating transforms lightweight 3D‐printed TPMS polymer lattices into effective electromagnetic shields. Topology, relative density, and conductive seed layer continuity govern copper penetration, electrical resistance, and attenuation. SEA consistently exceeds SER, while 35% RD Diamond lattice gives the best performance, reaching 48.72 dB
Aman Al Khatib   +6 more
wiley   +1 more source

Exceptional Elasto‐Dielectric Properties in a Highly Flexible Dielectric Elastomer Composite: The Key Roles of Parallel Elastic Nanofibers

open access: yesAdvanced Materials Technologies, EarlyView.
Soft dielectric elastomer composites often face a trade‐off between enhanced dielectric properties and mechanical compliance. Here, a parallel‐aligned polyurethane nanofiber network embedded in PDMS creates a flexible, durable composite with increased permittivity, low modulus, and fatigue stability after 100,000 cycles.
Yi Ge   +9 more
wiley   +1 more source

Moisture‐Adaptive Triboelectric Materials and Platforms: Design Strategies, Performance Enhancement, and Applications in Energy Harvesting and Wearable Electronics

open access: yesAdvanced Materials Technologies, EarlyView.
This review summarizes moisture‐adaptive strategies that enable triboelectric nanogenerators (TENGs) to operate across diverse moisture conditions. It examines moisture‐management methods, including exclusion, directional transport, removal, and utilization, with charge‐regulation approaches based on interfacial, dielectric, and structural engineering.
Junzhe Gan   +4 more
wiley   +1 more source

4D–Printed Photothermally Actuated Soft Microgripper on an Optical Fiber Tip for Biomedical Applications

open access: yesAdvanced Materials Technologies, EarlyView.
In this study, we developed a light–driven soft microgripper by 3D–printing a photo–crosslinkable, temperature–responsive hydrogel with embedded silver particles onto an optical fiber tip. The microgripper actuates via photothermal effects at cell culture temperature and can gently grasp spheroids without minimal damage, offering a compact, actuator ...
Shogo Oishi   +7 more
wiley   +1 more source

3D‐Printed Actuator Powered by Liquid Crystal Elastomer Muscles at the Water–Air Interface

open access: yesAdvanced Materials Technologies, EarlyView.
Soft robots for unstructured environments require responsive, durable actuators. Liquid crystal elastomers (LCEs) provide large reversible deformations under thermal or optical stimuli. Direct ink writing enables fabrication of LCE actuators integrated with silicone, with mesogen chemistry and oligomers optimized for printable inks.
Cecilie Ryberg   +5 more
wiley   +1 more source

Home - About - Disclaimer - Privacy