Results 11 to 20 of about 10,915 (306)
Highly Unequal Three-Port Power Divider: Theory and Implementation
International Journal of Antennas and Propagation, 2018 A three-port power divider consisting of a directional coupler, a Wilkinson power divider, and two transmission lines connected to them is proposed. Theoretical analysis reveals that highly unequal power division can be achieved by a feedback mechanism ...
Duolong Wu +3 more
doaj +2 more sources
Compact Unequal Power Divider with Filtering Response [PDF]
International Journal of Antennas and Propagation, 2015 We present a novel unequal power divider with bandpass responses. The proposed power divider consists of five resonators and a resistor. The power division ratio is controlled by altering the coupling strength among the resonators.
Wei-Qiang Pan +3 more
doaj +2 more sources
A Wideband RF Power Divider With Ultra-Wide Harmonics Suppression
IEEE Journal of Microwaves, 2023 This article reports a wide-band power divider with ultra-wide harmonic suppression. The filtering power divider consists of a Wilkinson power divider and a filter merged into a single structure.
Sikandar Abbas +5 more
doaj +2 more sources
Journal of Microwaves, Optoelectronics and Electromagnetic ApplicationsThis paper presents the design of broadband two way equal power divider in microstrip medium with defected ground structure suitable for broadband communication systems.
D. Packiaraj, M. Ramesh, A. T. Kalghatgi
doaj +2 more sources
IEEE Transactions on Power Systems, 2016 This paper derives analytical closed-form expressions that uncover the contributions of nodal active- and reactive-power injections to the active- and reactive-power flows on transmission lines in an AC electrical network. Paying due homage to current- and voltage-divider laws that are similar in spirit, we baptize these as the power divider laws ...
Yu Christine Chen, Sairaj V. Dhople
openaire +2 more sources
General design of multiway multisection power dividers by interconnecting two-way dividers [PDF]
, 2007 It is common practice to design multiway power dividers by interconnecting two-way power dividers. Transmission lines are used to link the two-way dividers.
Morris, KA +4 more
core +1 more source
Power divider with various power dividing ratios
Electronics Letters, 1999 A new power divider which has a completely planar structure and has various output power ratios is presented. This divider does not need any internal isolation resistors, and has almost perfect matching at all ports and perfect isolation characteristics.
Jong-Sik Lim +2 more
openaire +1 more source
A wideband CPW ring power combiner with low insertion loss and high port isolation [PDF]
, 2012 In this paper we present a coplanar waveguide (CPW)-based ring power combiner that exhibits less than 0.8 dB insertion loss, better than 15 dB port match and higher than 22 dB isolation loss over the frequency range from 50 GHz to 100 GHz.
Li, C. +4 more
core +1 more source
ETRI Journal, 2023 A filtering power divider based on air-filled substrate-integrated waveguide (AFSIW) technology is proposed in this study. The AFSIW structure is used in the proposed filtering power divider for substantially reducing the transmission losses.
Ali-Reza Moznebi +2 more
doaj +1 more source
Compact Dual-band Filtering Power Divider with Low Loss and High Isolation Based on Open-Circuited Stepped-impedance Resonators [PDF]
Journal of Microwaves, Optoelectronics and Electromagnetic ApplicationsIn this paper, a novel, compact, and high-performance dual-band filtering power divider is presented. The proposed circuit is constructed from a dual-band power divider and open-circuited stepped-impedance resonators.
Nguyen Minh Giang +4 more
doaj +1 more source