Results 91 to 100 of about 96,935 (306)
The optimal passive filters to minimize voltage harmonic distortion at a load bus [PDF]
, 2005 This material is posted here with permission of the IEEE. Such permission of the IEEE does not in any way imply IEEE endorsement of any of Brunel University's products or services. Internal or personal use of this material is permitted.
Zobaa, AF
core +1 more source
Advanced Healthcare Materials, EarlyView.This review examines how in vitro electrical and mechanical stimulation modulates wound healing in fibroblasts and keratinocytes. Analyzing over 560 experimental data points, we relate stimulation parameters to proliferation and migration outcomes, evaluate platform designs, and highlight the need for multi‐parameter optimization to advance targeted ...
Matthew K. Burgess +3 more
wiley +1 more source
Filtration of Harmonic Components and Correction Power Factor in Nonlinear Loads
Gazi Üniversitesi Fen Bilimleri Dergisi, 2019 Total harmonic distortion has become an important subject in power quality, especially after use of power electronic equipment and non-linear loads.
Süleyman ADAK +2 more
doaj +1 more source
EFISIENSI DAYA PADA BEBAN DINAMIK DENGAN KAPASITOR BANK DAN FILTER HARMONIK [PDF]
, 2011 Electrical power efficiency can be improved by improving power quality. Good power quality can be done by improving: the voltage drop, power factor, power loss and reduce harmonics. Use rectifier 3 phasa causing great harmonics.
Bambang Wahyono, Bambang +2 more
core
A 300-800MHz Tunable Filter and Linearized LNA applied in a Low-Noise Harmonic-Rejection RF-Sampling Receiver [PDF]
, 2010 A multiband flexible RF-sampling receiver aimed at software-defined radio is presented. The wideband RF sampling function is enabled by a recently proposed discrete-time mixing downconverter. This work exploits a voltage-sensing LNA preceded by a tunable
Klumperink, Eric A.M. +3 more
core +3 more sources
Advanced Materials, EarlyView.AI‐Assisted Workflow for (Scanning) Transmission Electron Microscopy: From Data Analysis Automation to Materials Knowledge Unveiling. Abstract (Scanning) transmission electron microscopy ((S)TEM) has significantly advanced materials science but faces challenges in correlating precise atomic structure information with the functional properties of ...
Marc Botifoll +19 more
wiley +1 more source
Comparison of current-source and voltage-source shunt active power filters for harmonic compensation and reactive power control [PDF]
, 2012 This paper presents the comparison between two three-phase Shunt Active Power Filters (SAPFs), one with Current-Source Inverter (CSI) and the other with Voltage-Source Inverter (VSI), which are used to compensate current harmonics and to ...
Afonso, João L. +5 more
core +1 more source
Advanced Materials, EarlyView.Transition metal oxy/carbo‐nitrides show great promise as catalysts for sustainable processes. A Mn‐Mo mixed‐metal oxynitride attains remarkable performance for the direct synthesis of acetonitrile, an important commodity chemical, via sequential C─N and C─C coupling from syngas (C1) and ammonia (N1) feedstocks.
M. Elena Martínez‐Monje +7 more
wiley +1 more source
Prony Analysis for Power System Transient Harmonics
EURASIP Journal on Advances in Signal Processing, 2007 Proliferation of nonlinear loads in power systems has increased harmonic pollution and deteriorated power quality. Not required to have prior knowledge of existing harmonics, Prony analysis detects frequencies, magnitudes, phases, and especially damping
Qi Li +3 more
doaj +2 more sources
Model predictive control based selective harmonic control-PWM strategy for active power filters
International Journal of Electrical Power & Energy SystemsActive power filters are widely used to improve power quality and mitigate harmonic distortion caused by non-linear loads and grid-connected generation units.
Irati Ibanez-Hidalgo +5 more
doaj +1 more source