Results 11 to 20 of about 223,741 (257)
Using the unit software model to improve design solutions and optimize process management [PDF]
Nuclear Energy and Technology, 2021 Advanced design power units are distinguished by a high degree of digital transformation. Therefore, of particular interest are operator information (intelligent) support systems, which can reduce the workload on operating personnel as well as predict ...
Dmitry B. Statsura +6 more
doaj +3 more sources
Natural gas combined cycle power plant aggregated with battery: a flexible hybrid solution providing enhanced frequency and balancing services [PDF]
E3S Web of Conferences, 2019 The growth of renewable sources and the consequent complexity in the management of the electric grid draw a scenario in which the traditional fossil fuel power plants are asked to improve their performances to continue playing a primary role for the ...
Giacchino Alessandro, Repetto Enrico
doaj +1 more source
Research on cleaning scheme of photovoltaic power plant based on pollutant composition analysis [PDF]
E3S Web of ConferencesSolar photovoltaic (PV) modules, as an important component of the photovoltaic conversion process within a PV system, are closely related to the efficiency and service life of the PV system’s overall work performance.
Cheng Wenji +5 more
doaj +1 more source
Aerosol and Air Quality Research, 2022 At present, filterable particulate matter (FPM) emissions from stable source flue gases are well controlled, and the more difficult to remove condensable particulate matter (CPM) has received much attention due to its environmental hazards. In this study,
Wenting Liu +4 more
doaj +1 more source
发电技术, 2023 As the “dual carbon” goal has been upgraded to a national strategy, coal-fired power plants are the top priority for carbon reduction in the power generation industry, and coal-fired power plants are facing a huge challenge in limiting carbon emissions ...
CHEN Siqin +3 more
doaj +1 more source
Aerosol and Air Quality Research, 2022 “Clean Heating” (CH) was promoted in 2017 in north China. Nevertheless, CH impacts on PM2.5 chemical components, sources, and health risks in small cities remain unclear.
Dingyuan Yang +14 more
doaj +1 more source
AIP Advances, 2018 The Flame pyrolysis method used to synthesize carbon nanotubes was studied in this work. In order to improve the quality of synthesized carbon nanotubes, it is important to change the corresponding natures of the catalyst.
Yonghong Guo +8 more
doaj +1 more source
Energies, 2018 Organic Rankine cycle (ORC) is a reliable technology to recover low-grade heat sources. The radial-inflow turbine is a critical component, which has a significant influence on the overall efficiency of ORC system.
Peng Li +4 more
doaj +1 more source
Aerosol and Air Quality Research, 2023 Emissions of total particulate matter (TPM) from stationary combustion sources consist of both filterable particulate matter (FPM) and condensable particulate matter (CPM). According to the study’s findings, CPM emissions contributed significantly to the
Wenting Liu +3 more
doaj +1 more source
IEEE AccessIncremental randomized neural networks have been widely applied in industrial data modeling. However, incremental randomized neural networks may generate redundant hidden nodes.
Xinlei Li +7 more
doaj +1 more source