Results 1 to 10 of about 1,544,263 (230)

The use of numerical simulation to determine the coal combustion efficiency in the A-USC boiler [PDF]

open access: yesE3S Web of Conferences, 2023
In this paper, numerical simulation of coal combustion in the invert furnace of a boiler for a 500 MW power unit designed to operate on advanced ultra-supercritical steam parameters (A-USC) is performed.
Fomenko Nadezhda   +2 more
doaj   +1 more source

Influence of external supply of low-grade heat on thermal efficiency of sCO2 power cycles [PDF]

open access: yesE3S Web of Conferences, 2023
The effect of supply of additional external low-grade heat on overall thermodynamic efficiency is considered using the example of a cycle with a two-stage pressure increase by a compressor and a pump (by analogy with the Allam cycle).
Sadkin Ivan, Shchinnikov Pavel
doaj   +1 more source

On the scalability of the operating capacity of hydrogen recombiners [PDF]

open access: yesNuclear Energy and Technology, 2022
One of the main factors in the capacity of passive autocatalytic recombiners (PARs) is its productivity or the hydrogen removal rate. In this work it was demonstrated that regardless of the type of a recombiner, the hydrogen removal rate is mostly ...
Alexandr V. Avdeenkov   +3 more
doaj   +3 more sources

Investigation of the composition and causes of membrane fouling of reverse osmosis [PDF]

open access: yesE3S Web of Conferences, 2020
The report shows the results of investigation of the composition of fouling formed during Sheshma river water softening reverse osmosis filter. A research technique is disclosed, which includes energy dispersive spectroscopy and ATR FTIR spectroscopy ...
Saitov Stanislav, Chichirova Natalia
doaj   +1 more source

Study on Stability of Gas Pressure Regulator with a Built-In Silencer

open access: yesEnergies, 2022
Gas pressure regulators are widely used in gas transportation and distribution systems. They are designed for deep pressure reduction and maintainance with high accuracy over a wide flow range.
Dmitry Stadnik   +5 more
doaj   +1 more source

Study of elementary composition and structural characteristics of high-ash brown coal of angren deposit [PDF]

open access: yesE3S Web of Conferences, 2020
The results of the study of the composition and characteristics of high-ash brown coal of the Angren deposit, used in the power industry of the Republic of Uzbekistan are presented. A feature of this coal is the presence in the composition of the fuel of
Babakhodjaev Rakhimjan   +3 more
doaj   +1 more source

Advanced Algorithms in Automatic Generation Control of Hydroelectric Power Plants

open access: yesMathematics, 2022
The problem of load distribution between hydraulic units at hydropower plants is a difficult task due to the nonlinearity of hydro turbine characteristics and individual peculiarities of the generation units, in which operating conditions are often ...
Yury V. Kazantsev   +4 more
doaj   +1 more source

A New Maximum Power Point Tracking Technique for Thermoelectric Generator Modules

open access: yesInventions, 2021
Thermoelectric generators (TEGs) are devices that convert heat into electricity. This paper is about the design of a Maximum Power Point Tracking (MPPT) technique for a TEG module. The module is built using 204 TEGs connected in series.
Mohammed A. Qasim   +4 more
doaj   +1 more source

Nuclear Power Plant or Solar Power Plant

open access: yes, 2021
Both solar energy and nuclear energy face significant economic challenges. Sustainable energy costs have traditionally been greater than any of those associated with the growth of fossil fuel power generation, although the costs of renewable energy technologies (especially photovoltaic) have dropped. Furthermore, capital costs remain a big challenge in
Shayan, Mostafa, Esmaeili   +1 more
openaire   +3 more sources

Investigation of the probability of existence of defects with a size exceeding the allowed value

open access: yesStructural Mechanics of Engineering Constructions and Buildings, 2020
Relevance. Non-destructive testing of metal determines the actual state of the metal, the presence of discontinuities and their sizes, and also allows to determine what mechanisms of metal degradation were subjected to. One of the main characteristics of
Dmitry A. Kuzmin   +2 more
doaj   +1 more source

Home - About - Disclaimer - Privacy