Results 21 to 30 of about 9,125,519 (306)
Research on mine pump motor energy saving test system and dynamic loading characteristics
The test technology of hydraulic simulation loading and hydraulic power recovery are used to design an energy saving test system for mine pump and motor,and the dynamic load characteristics of the test system are analyzed and simulated in AMESim.Research
Wu Yong +3 more
doaj +1 more source
Energy recovery power supply for piezoelectric actuator [PDF]
Piezoelectric actuators are used successfully to enable locomotion of micro-robot such as micro air vehicle with flapping wings. However, the use of piezoelectric actuators presents a major challenge for power electronic design: the input capacitance of such devices makes their use delicate because the instantaneous power may be much greater than the ...
Vasic, Dejan, Costa, François
openaire +2 more sources
Design and Potential Power Recovery of Two Types of Energy Harvesting Shock Absorbers
Numerous authors have studied Energy Harvesting Shock Absorbers (EHSA) over the last decade, proposing different designs with diverse geometries, parameters, and components.
L. Bowen +2 more
semanticscholar +1 more source
Condenser Optimization of Heat Pipe
Construction of heat exchanger assembly has important role for efficient operation of energy systems. Within this assembly a heat pipe is utilized for heat transfer. The condensation part of the heat pipe is situated on top of the heating zone.
Radovan Nosek +4 more
doaj +1 more source
At present, systems for wind power transmission by ultra-high voltage direct current (UHVDC) and ultra-high voltage alternating current (UHVAC) have been constructed and are operating in China. The installed capacity of the doubly fed induction generator
Yan Zhang +5 more
semanticscholar +1 more source
Oil Contact Angles in a Water-Decane-Silicon Dioxide System: Effects of Surface Charge
Oil wettability in the water-oil-rock systems is very sensitive to the evolution of surface charges on the rock surfaces induced by the adsorption of ions and other chemical agents in water flooding.
Shijing Xu +5 more
doaj +1 more source
In steam assisted gravity drainage (SAGD) process, there is an uneven distribution of steam chamber growth along the whole length of the horizontal well. In order to solve this problem, a three-dimensional high-pressure physical model of a SAGD well pair
Desheng MA +5 more
doaj +1 more source
When the thickness of the solar cell wafer and the amount of Ag to be used decreases, it is the best method to recover the power of the module after use at a minimum cost and reuse the module itself.
Koo Lee +3 more
doaj +1 more source
GaN HEMT class-E rectifier for DC+AC power recovery
A 915 MHz GaN HEMT-based class-E rectifier is proposed in this paper to be used for DC+AC wireless power recovery. Taking advantage of the time reversal (TR) duality principle, the rectifier was derived from a class-E inverter, whose output network was ...
M. Ruiz +3 more
semanticscholar +1 more source
Machinery Early Fault Detection Based on Dirichlet Process Mixture Model
The most commonly used single feature-based anomaly detection method for the complex machinery, such as large wind power equipment, steam turbine generator sets, and reciprocating compressors, exhibits a defect of low-alarm accuracy due to the non ...
Bo Ma +4 more
doaj +1 more source

