Results 121 to 130 of about 3,325 (167)
Some of the next articles are maybe not open access.
Measurement of Ground Potential Difference at Power Substations
IEEE Power Engineering Review, 1991A method of obtaining a record of ground potential difference (GPD) values in substations where a remote ground and an oscillograph are available is presented. Typical recorded values of GPD range from under 100 V to a maximum of 450 V RMS. These measurements suggest that the values used for ground mat design should be considered by the telephone ...
P. Lipavsky, R.E. Nienaber
openaire +1 more source
A Comprehensive Power Quality Controller for Substations in Power System
Twenty-First Annual IEEE Applied Power Electronics Conference and Exposition, 2006. APEC '06., 2006A comprehensive power quality controller combined with thyristor controlled reactor (TCR) and hybrid active power filter (HAPF) is described in this paper for substations in power system. The HAPF topology presented in the paper is different from the conventional HAPF.
X. Zhang +6 more
openaire +1 more source
Electric Power Substations Engineering
2016HOW A SUBSTATION HAPPENS Jim Burke and Anne-Marie Sahazizian GAS-INSULATED SUBSTATIONS Phil Bolin AIR-INSULATED SUBSTATIONS-BUS/SWITCHING CONFIGURATIONS Michael J. Bio HIGH-VOLTAGE SWITCHING EQUIPMENT David L. Harris and E. David Childress HIGH VOLTAGE POWER ELECTRONICS SUBSTATIONS Gerhard Juette and Asok Mukherjee THE INTERFACE BETWEEN AUTOMATION AND ...
openaire +1 more source
IT integration in power distribution substation, AADC substations' automation and management
2011 International Conference on Innovations in Information Technology, 2011The objective of this paper is to introduce the Information Technology (IT) adapted by Al Ain Distribution Company (AADC) engineers toward establishing the Smart Grid (SG). In the way to establish a SG the quality of supply is improved in continuous steps along with the desire to protect the environment.
openaire +1 more source
Fuzzy Control on Voltage/Reactive Power in Electric Power Substation
2009A fuzzy method using in voltage and reactive power control in electric substation is proposed based on the improved 17 Areas Method derived from 9 Areas Method. A simulation model is founded with fuzzy control rules used the Matlab simulink. The simulation results indicate that voltage of the model with fuzzy control is less fluctuating and much ...
Xiuhua Wu +3 more
openaire +1 more source
Computer vision applications in power substations
2004 IEEE International Conference on Electric Utility Deregulation, Restructuring and Power Technologies. Proceedings, 2004Computer vision is a quite mature technology nowadays and it is very useful for power system monitoring applications. In this paper, some computer vision applications in a power substation will be reported. The system implemented is able to conduct automatically intruder detection, fire alarm zone detection and substation meter reading.
W.L. Chan, S.L.P. Leo, C.F. Ma
openaire +1 more source
Smart substation for the French power grid
2016 69th Annual Conference for Protective Relay Engineers (CPRE), 2016The paper describes a smart substation project launched two years ago, as part of the French government's plan “investments for the future”. This project is named “Poste Intelligent” within RTE (Smart Substation, in English), and aims to test in real conditions the latest technological developments for both primary and secondary equipment using the ...
Thierry Buhagiar +4 more
openaire +1 more source
Applications of new technology in power substations
IEEE Transactions on Power Delivery, 1990Applications of some of the more modern technologies to instruments designed specifically to operate in utility substation environments are described. Particular emphasis is placed on the use of CMOS logic, processor and memory circuits, high-density flexible magnetic disk media, and high-capacity Winchester technology storage devices.
R.O. Burnett, R.J. Murphy
openaire +1 more source
EMI and Wireless Communications in Power Substations
2018This chapter gives a general overview of EMI and describes the measurement and characterization methods associated with them, in keeping with the latest research. Impulsive noise phenomenon in substations is particularly focused and existing impulsive noise models are discussed.
Basile L. Agba +4 more
openaire +1 more source
Calculation of power losses in the transformer substation
2016 13th International Scientific-Technical Conference on Actual Problems of Electronics Instrument Engineering (APEIE), 2016In the article the analysis of power losses in electric networks, which are one of the most important indicators of economic efficiency of their work is given. As the automated measurement tools allowing to supervise current loads of electricity networks elements, are installed in a limited number in power systems, then the calculation of the ...
V.I. Biryulin +3 more
openaire +1 more source