Results 1 to 10 of about 84,620 (165)
Time Dependency of Current Harmonics for Switch-Mode Power Supplies
Applied Sciences, 2020 This paper presents the time-dependent variance in the current harmonics emission by power supplies during power quality measurements. Power quality problems are becoming more significant with the adoption of power electronic-based circuits such as power
Muhammad Naveed Iqbal +5 more
doaj +3 more sources
Energies, 2022 This paper presents a novel capacitor voltage balancing control approach for cascaded multilevel inverters with an arbitrary number of series-connected H-Bridge modules (floating capacitor modules) with asymmetric voltages, tiered by a factor of two ...
Manuel Kuder +10 more
doaj +1 more source
Best Practices for Advanced Modeling of Safety Mechanisms in an FTA
IEEE Access, 2023 To cope with the megatrends electrification, automated driving, and connectivity, new functionalities and electric and/or electronic systems must be developed, which require a safe power supply.
Philipp Kilian +7 more
doaj +1 more source
Emergency Operation in the Power Supply Domain According to ISO 26262
IEEE Access, 2022 The automotive industry is currently driven by the megatrends electrification, automated driving, and connectivity. To cope with these trends, new functionalities and electric and/or electronic systems must be developed, which require a safe power supply
Philipp Kilian +5 more
doaj +1 more source
Emergency Operation in the Power Supply Domain Focusing on Warm Redundancy
IEEE Access, 2022 To cope with the megatrends electrification, automated driving, and connectivity, new functionalities and E/E systems must be developed, which require a safe power supply. This leads to increased functional safety requirements for the power supply system,
Philipp Kilian +5 more
doaj +1 more source
Analysis of Plasma Reactor Interaction with the Power Grid Depending on the Power Supply Design
Applied Sciences, 2023 In this paper, the collaboration of a GlidArc-type plasma reactor with four dedicated power supplies was analysed. Each power supply is characterised by a different design solution. Plasma generation by electrical discharge requires a careful analysis of
Grzegorz Komarzyniec, Michał Aftyka
doaj +1 more source
Stand-alone power supplies for relay protection [PDF]
Омский научный вестник, 2018 At present, telemetry and relay protection devices, which are located directly on the protected element of the electric power system or inside it, are increasingly used in the electric power industry. To supply them requires an autonomous source of low
T. A. Novozhilov +3 more
doaj +1 more source
Principle Guidelines for Safe Power Supply Systems Development
IEEE Access, 2021 The relevance of safety applications within the automotive industry is increasing continuously, e.g. due to vehicle automation and decreasing relevance of mechanical backups.
Philipp Kilian +6 more
doaj +1 more source
Safety-Related Availability in the Power Supply Domain
IEEE Access, 2022 The automotive industry is currently driven by the megatrends electrification, automated driving and connectivity. To cope with these trends, new functionalities and electrical and/or electronic (E/E) systems need to be developed and deployed ...
Philipp Kilian +4 more
doaj +1 more source
Ultra-Low Percentage Flicker High-Efficiency Direct AC LED Driver Using Constant Power Technology
IEEE Access, 2023 According to California’s 2016 Building Energy Efficiency Standards, the percentage flicker of light-emitting diode (LED) lighting fixtures should be below 30%. However, the percentage flicker of commercially available linear power supplies
San-Fu Wang +4 more
doaj +1 more source