Electrically Tunable On‐Chip Topological Photonics with Integrated Carbon Nanotubes
This work demonstrates electrically tunable on‐chip topological THz devices by integrating 2D carbon nanotube (CNT) sheets with valley‐Hall photonic crystals, enabling broadband transmission modulation (71% modulation depth) and tunable narrowband filtering (0.54 GHz shift) through electrically induced thermal tuning. This advancement paves the way for
Jifan Yin +7 more
wiley +1 more source
Performance Optimization of Triangular Cantilever Beam Piezoelectric Energy Harvesters: Synergistic Design Research on Mass Block Structure Optimization and Negative Poisson's Ratio Substrate. [PDF]
Ren R +5 more
europepmc +1 more source
Modeling and simulation of a hybrid PV/wind/battery storage off-grid power system
Tareq Kareri
openalex +1 more source
A Multi-Beam Phased Array Receiver Front-End with High Performance Ceramic SiP. [PDF]
Zhang H, Guo LX, Dun S, Li X, Xu X.
europepmc +1 more source
Improved one-dimensional residual network high-voltage DC diagnosis for high-precision fault identification. [PDF]
Li R, Zhang X, Hao W, Wang T.
europepmc +1 more source
Analysis of the impact of non-real-time frequency sampling and damping coefficient on the dynamic frequency support response of grid-forming type renewable energy. [PDF]
Tao X +5 more
europepmc +1 more source
A fast regulation algorithm for low voltage in regional grids with high uncertainty and high penetration of wind and solar loads at the grid end. [PDF]
Kang H +6 more
europepmc +1 more source
Mixed-mode control of multiphase interleaved parallel circuit for pulsed laser diode driving. [PDF]
Wu B, Liu J, Zhao H, Guo J, Liu Z.
europepmc +1 more source
Related searches:
Satellite power system simulation
Acta Astronautica, 1997Abstract In order to furnish a useful tool for the power system preliminary sizing, a satellite power system simulator was developed. The simulator has a modular structure where each module implements the mathematical model of the system components (solar array, battery, voltage regulators etc.).
COLOMBO G +4 more
openaire +2 more sources
Simulated power system restoration
2008 43rd International Universities Power Engineering Conference, 2008Outage time after extensive blackouts depends very much on the power system restoration process. Power system restoration is a very challenging task to the operator since the situation is so far from normal conditions. This paper proposes a simulation-based tool that determines a feasible sequence of operator actions that restores power system ...
Olof Samuelsson +2 more
openaire +1 more source

