Results 131 to 140 of about 2,279,988 (303)
La realización de este proyecto, engloba tanto el análisis de la situación actual correspondiente a la investigación de la viabilidad potencial de la tecnología Power to Gas fundamentada en pruebas y ensayos, como la posible evolución y desarrollo de dicha tecnología de cara al futuro a corto y a largo plazo.
openaire +2 more sources
Interaction of Ladle Slag With Varying SiO2 Content and Recyclate‐Based MgO–C Refractories
Ladle slags (CaO/Al2O3 = 1) with 1–20 wt% SiO2 were investigated in contact with industrial MgO–C refractories fabricated from fresh magnesia and 50 wt% recyclate. The sessile drop method at 1600°C reveals intensive gas formation, delayed slag infiltration in recyclate‐based samples, and, under high‐SiO2 slag, formation of a dense MgAl2O4‐rich ...
Anton Yehorov +6 more
wiley +1 more source
This paper presents a novel approach to reducing oxide layers on metal powders using low‐temperature hydrogen dielectric barrier discharge plasmas at atmospheric pressure. Unlike conventional hydrogen‐plasma reductions, the powders do not contact the plasma directly.
Shukang Zhang +3 more
wiley +1 more source
Deterministic Detection of Single Ion Implantation
Focused ion beam implantation with high detection efficiencies will enable the rapid and scalable fabrication of advanced spin‐based technologies such as qubits. This work presents the detection efficiencies of a wide range of ions implanted into solid‐state hosts, with efficiencies of >90% recorded for ion species and substrate combinations of ...
Mason Adshead +6 more
wiley +1 more source
Surface Tension Measurement of Ti‐6Al‐4V by Falling Droplet Method in Oxygen‐Free Atmosphere
In this article, the temperature‐dependent surface tension of free falling, oscillating Ti‐6Al‐4V droplets is investigated in both argon and monosilane doped, oxygen‐free atmosphere. Droplet temperature and oscillation are captured with one single high‐speed camera, and the surface tension is calculated with Rayleigh's formula.
Johannes May +9 more
wiley +1 more source
Energy Conversion Alternatives Study (ECAS), Westinghouse phase 1. Volume 5: Combined gas-steam turbine cycles [PDF]
The energy conversion efficiency of gas-steam turbine cycles was investigated for selected combined cycle power plants. Results indicate that it is possible for combined cycle gas-steam turbine power plants to have efficiencies several point higher than ...
Amos, D. J. +2 more
core +1 more source
Creating Ti–Fe α/β Alloys by Diffusion‐Driven Solid‐State Processing
This study proposes making alloys containing fast diffusing elements that are difficult to produce by ingot metallurgy, by diffusion‐driven solid‐state HIP processing of elemental powders and low‐temperature homogenisation. Here, novel Fe‐Ti α–β alloys are formed having fine α–β lamellae, a small β prior grain size without significant intermetallics ...
Jiaqi Xu +10 more
wiley +1 more source
In view of the carbon emission reduction and new energy consumption problems in the integrated energy system (IES), this paper, for the first time, combines power to gas (P2G) with liquid carbon dioxide energy storage (LCES) and takes demand response (DR)
Liang Zhang +7 more
doaj +1 more source
Power to gas: diplôme 2015 [PDF]
Le but principal du travail est de mettre en place un système power to gaz entier afin de montrer et expliquer les étapes principales. Ceci exige de Construire et mettre en route l’électrolyseur tri-cellule. Mettre en place et faire fonctionner le méthaniseur Gérer des éléments de mesure et des actionneurs avec un automate afin de faciliter la ...
Constantin, David, Ellert, Christoph
openaire
Cermets (60 vol.% AISI 316L stainless steel, 40 vol.% recycled MgO), intended for use in aluminum electrolysis, were pre‐oxidized in three furnaces with different heating technologies and subjected to a cryolite corrosion test. The different atmospheres influenced the formation of oxide layers, which in turn affected corrosion resistance and ...
Patricia Kaiser +4 more
wiley +1 more source

