Results 121 to 130 of about 483,363 (313)
A Way to Use Waste Heat to Generate Thermoelectric Power
Acta Polytechnica, 2012 In recent years there has been rising interest in thermoelectric generation as a potential source of electric power using waste heat. This paper describes thermoelectric power generation from waste heat from biomass boilers, utilizing generators that can
Marian Brázdil, Jiří Pospíšil
doaj
Advanced Engineering Materials, EarlyView.This article presents the design, modeling, and characterization of air‐pressure–actuated programmable vibroacoustic metamaterials (PVAMM). The study focuses on leveraging air pressure to dynamically tune resonance frequencies for effective noise attenuation.
William Kaal +2 more
wiley +1 more source
Socio-Economic Impact Assessment of the University of Strathclyde's Combined Heat and Power Project [PDF]
, 2018 The University of Strathclyde is investing £650 million over the course of this decade to transform the Strathclyde campus into a first-class working and learning environment for students and staff.
Black, James
core
Advanced Engineering Materials, EarlyView.Disordered (Fe50Co50)1−xPtx thin films exhibit a pronounced anomalous Nernst effect (ANE) with a strong composition dependence on both rigid and flexible substrates. The transverse thermoelectric response peaks near 22.5 at.% Pt, accompanied by enhanced αxy/σxy scaling, thermal transport, and ANE sensitivity.
Mojtaba Mohammadi +2 more
wiley +1 more source
Powder Optimization Strategies for Binder Jetting Printing of BaTiO3 and Ba0,6Sr0,4TiO3 Ceramics
Advanced Engineering Materials, EarlyView.Powder optimization is investigated to enable binder jetting of BaTiO3 and Ba0.6Sr0.4TiO3 ferroelectric ceramics. The antagonistic relationship between flowability and binder compatibility is addressed through binder impregnation of granulated powders and fumed silica addition to fine powders.
Fanny Pruvost +4 more
wiley +1 more source
Advanced high temperature latent heat storage system - design and test results
, 2009 Processes with a two-phase heat transfer fluid (e.g. water/steam) require isothermal energy storage. Latent heat storage systems are an option to fulfil this demand.
Laing, Doerte +3 more
core
The deterioration in heat transfer to fluids at super-critical pressure and high heat fluxes [PDF]
, 1968 Introduction: Several supercritical steam generators in the American Electric Power system have shown evidence of tube overheat in the lower furnance at the point where the water bulk temperature is about 670 0 F. The evidence is of two kinds.
Griffith, P., Shiralkar, B. S.
core
, 2019 Heat and mass transfer is the core science for many industrial processes as well as technical and scientific devices. Automotive, aerospace, power generation (both by conventional and renewable energies), industrial equipment and rotating machinery ...
core +1 more source
Low‐Angle Grain Boundaries and Re‐Segregation in Single‐Crystalline Ni‐Base Superalloys
Advanced Engineering Materials, EarlyView.This work demonstrates that Re‐segregation at low‐angle grain boundaries (LAGBs) in Ni‐base superalloys is influenced by misorientation angle. Advanced microscopy and atom probe tomography reveal that higher misorientation angles increases Re‐segregation.
Alireza B. Parsa +9 more
wiley +1 more source
The effect of nonuniform axial heat flux distribution on the critical heat flux [PDF]
, 1965 A systematic experimental and analytic investigation of the effect of nonuniform axial heat flux distribution on critical heat rilux was performed with water in the quality condition.
Todreas, Neil E., Rohsenow, Warren M.
core