Results 161 to 170 of about 286,218 (312)

Creep Properties and Deformation Mechanism of Additively Manufactured NiAl‐CrMo Composites

Advanced Engineering Materials, EarlyView.
Additively manufactured NiAl‐CrMo composites contain numerous interfaces and cell boundaries that control their creep response. At 700°C under high applied stress, creep is dominated by dislocation‐controlled power‐law mechanisms. At 800°C–900°C and lower stresses, creep is primarily diffusion‐controlled along cell boundaries.
Jan Vollhüter, Andreas Bezold, Johan Westraadt, Katharina Fiegl, Subham Chattoraj, Benjamin Wahlmann, Carolin Körner, Michael Mills, Mathias Göken, Steffen Neumeier   +9 more
wiley   +1 more source

Enhanced Strength and Corrosion Resistance of Ti‐13Nb‐12Ta‐10Zr‐4Sn Alloy by Aging Treatment

Advanced Engineering Materials, EarlyView.
This work systematically investigates the effect of aging treatment on mechanical properties and corrosion behavior of vacuum arc‐melted Ti‐13Nb‐12Ta‐10Zr‐4Sn alloy. Owing to the increased α″ martensite, strength and corrosion resistance were significantly enhanced by aging treatment.
Yuhua Li, Rong Zhao, Qian Zhang, Haojie Wang, Yujing Liu, Lai‐Chang Zhang   +5 more
wiley   +1 more source

Evaluation of Plasticity and Creep Parameters From Tensile Stress–Strain Data for a Range of Strain Rates

Advanced Engineering Materials, EarlyView.
This plot compares experimental tensile stress–strain curves (with 4 different strain rates) and corresponding modelled curves (obtained using the optimised sets of Voce and Miller–Norton parameter values shown). The inferred M‐N values, characterizing the creep, are very similar to those obtained via conventional creep testing.
S. Ooi, R. P. Thompson, T. W. Clyne
wiley   +1 more source

Precipitation and fracture in a ferritic stainless steel

, 2000
Includes bibliographical references.A dual stabilised ferritic stainless steel with titanium and niobium additions had been experiencing failures during production. Following hot rolling and cooling while coiled and prior to annealing, the steel had been
Scott, Adam James Lidstone
core  

Chemical Kinetic and Mechanistic Investigation of Cobalt and Manganese Recovery from Aqueous Solutions by Ozone Oxidative Precipitation. [PDF]

Environ Sci Technol
Shekarian Y, Rezaee M, Pisupati SV.
europepmc   +1 more source

In Situ Micromechanical Study of Bimodal γ′–γ″ Precipitate Assemblies in Ni–Cr–Al–Nb Superalloy

Advanced Engineering Materials, EarlyView.
A Ni–Cr–Al–Nb superalloy with a bimodal γ′–γ″ precipitate distribution is developed. Composite precipitate assemblies form through heterogeneous nucleation, effectively impeding dislocation motion. Micropillar compression reveals high strength at room and elevated temperatures, governed by precipitate shearing, with coupled faulting mechanisms ...
Ujjval Bansal, Tae‐Hyeok Kang, Pyuck‐Pa Choi, Subin Lee, Christoph Kirchlechner   +4 more
wiley   +1 more source

Microbial CaCO3 precipitation for the production of biocement

, 2004
The hydrolysis of urea by the widely distributed enzyme urease is special in that it is one of the few biologically occurring reactions that can generate carbonate ions without an associated production of protons. When this hydrolysis occurs in a calcium-
Whiffin, Victoria S.
core  

Large-scale circulation shapes the spatial organization of anomalous precipitation over Northern Jiangsu. [PDF]

iScience
Xu Y, Fang H, Zhao W, Zhang J, Ma S, Zhou C, Shi M.   +6 more
europepmc   +1 more source

Experimental Characterization and Constitutive Modeling of the Effect of Prior Inelastic Strain on the Viscoplastic Behavior of AD730 at 700 °C

Advanced Engineering Materials, EarlyView.
This study shows that superalloys used in aircraft engine disks become much more prone to deformation at high temperatures if they have been strained during manufacturing. This effect increases with the level of prior strain but eventually reaches a limit.
Fabio Machado Alves da Fonseca, Patrick Villechaise, Malik Durand, Arnaud Longuet, Florent Coudon, Loïc Signor, Julien De Jaeger, Dominique Eyidi, Nathalie Bozzolo, Jonathan Cormier   +9 more
wiley   +1 more source

Ternary Phase Equilibria of the Sclareol-Ethyl Lactate-CO2 System and its Application in the Extraction and Isolation of Sclareol from Clary Sage

, 2009
The purpose of the research is to develop an environmentally responsible process to extract sclareol from Salvia sclarea L., more commonly known as Clary Sage.
Tombokan, Xenia Clarissa
core