Results 131 to 140 of about 36,817 (300)

Measurement of Pressure Pulsations in Francis Turbines

open access: yes, 2010
The work presented in this thesis involves preparation and execution of measurements on Francis runners. The measurements were performed by means of onboard measuring equipment both in model runners and full-scale prototype runners. Also, analysis of the measured data, and the discussion of the results, is presented.
openaire   +2 more sources

Digital Actuation Control of Soft Robotic Origami With Self‐Folding Liquid Crystal Elastomer Hinges

open access: yesAdvanced Functional Materials, EarlyView.
Self‐folding soft‐rigid hybrid robotic origami is enabled by liquid crystal elastomer actuators with embedded Joule heating and closed‐loop digital control. Digitally addressable hinges provide reversible and programmable transitions between distinct folded states while maintaining actuation performance at high cycle counts (over 1500).
David C. Bershadsky   +3 more
wiley   +1 more source

Meta‐Rod Mechanical Metamaterials With Programmable Reconfiguration

open access: yesAdvanced Functional Materials, EarlyView.
Existing mechanical metamaterials achieve programmable large deformations in planar square or cubic configurations, restricted by required complex boundary conditions. This research proposes a 1D metamaterial, Meta‐rod, with linear, bending, twisting, area, and volume deformation modes.
Atharva Pande, Lyes Kadem, Hang Xu
wiley   +1 more source

Intermediate Resistive State in Wafer‐Scale Vertical MoS2 Memristors Through Lateral Silver Filament Growth for Artificial Synapse Applications

open access: yesAdvanced Functional Materials, EarlyView.
In MOCVD MoS2 memristors, a current compliance‐regulated Ag filament mechanism is revealed. The filament ruptures spontaneously during volatile switching, while subsequent growth proceeds vertically through the MoS2 layers and then laterally along the van der Waals gaps during nonvolatile switching.
Yuan Fa   +19 more
wiley   +1 more source

Integration of Low‐Voltage Nanoscale MoS2 Memristors on CMOS Microchips

open access: yesAdvanced Functional Materials, EarlyView.
This article presents the first monolithic integration of nanoscale MoS2‐based memristors into the back‐end‐of‐line of foundry‐fabricated CMOS microchips in a one‐transistor‐one‐resistor (1T1R) architecture. The MoS2‐based 1T1R cells exhibit forming‐free, nonvolatile resistive switching with ultra‐low operating voltages, low cycle‐to‐cycle variability ...
Jimin Lee   +16 more
wiley   +1 more source

Numerical study on the hydrodynamic characteristics of multi-stage centrifugal pumps influenced by impeller-guide vane clocking effect

open access: yesEngineering Applications of Computational Fluid Mechanics
A high-speed multi-stage centrifugal pump building upon a transient investigation into the hydrodynamic characteristics, is conducted for 16 sets of clocking positions. The most significance of the pump head has a maximum increase of 3.6% at 0.8Qd. Phase
Qiaorui Si   +5 more
doaj   +1 more source

A New Threshold Switching Device With Tunable Negative Differential Resistance Based on ErMnO3 Polymorphs

open access: yesAdvanced Functional Materials, EarlyView.
Polymorph engineering in ErMnO3 enables low‐voltage, forming‐free threshold switching with tunable negative differential resistance. Conducting orthorhombic regions embedded in an insulating hexagonal matrix provide controlled Joule‐heating‐enhanced Poole–Frenkel transport. The hexagonal phase prevents excessive heating and breakdown.
Rong Wu   +8 more
wiley   +1 more source

2D Magnetic and Topological Quantum Materials and Devices for Ultralow Power Spintronics

open access: yesAdvanced Functional Materials, EarlyView.
2D magnets and topological quantum materials enable ultralow‐power spintronics by combining robust magnetic order with symmetry‐protected, Berry‐curvature‐driven transport. Fundamentals of 2D anisotropy and spin‐orbit‐coupling induced band inversion are linked to scalable growth and vdW stacking.
Brahmdutta Dixit   +5 more
wiley   +1 more source

High‐Resolution and Real‐Time In Situ Generation of Cellular Spheroids by Laser‐Assisted Bioprinting for Guided Microvascularization

open access: yesAdvanced Functional Materials, EarlyView.
Micro‐injection laser‐assisted bioprinting enables ultrafast and precise patterning of small endothelial cell spheroids by injecting a highly concentrated single‐cell suspension into GelMA/ColMA hydrogels. In co‐culture with fibroblasts, controlled pre‐vasculogenic network formation is obtained at microscale resolution.
Charles Handschin   +9 more
wiley   +1 more source

Temperature‐Modulated Threshold Response in a Volatile Memristor: Toward a Biomimetic Polymodal Nociceptive System

open access: yesAdvanced Functional Materials, EarlyView.
This study demonstrates an artificial polymodal nociceptor whose firing threshold is actively modulated by temperature. A volatile TiN/TiOx/ZnO/TiOx/ITO memristor shows interfacial ion–driven resistive switching and membrane‐potential‐like dynamics, enabling temperature‐dependent nociceptive behavior.
Chanmin Hwang   +3 more
wiley   +1 more source

Home - About - Disclaimer - Privacy