Results 41 to 50 of about 22,007,736 (349)
Technology options for embedding low-profile electronic components in printed circuit boards
Tekhnologiya i Konstruirovanie v Elektronnoi Apparature, 2018 In order to improve the overall characteristics of printed circuit boards, two technologies for the formation of multilayer printed circuit boards have been developed - with the embedding of low-profile electronic components in a layer of fiberglass and ...
A. A. Efimenko, V. O. Ryabov
doaj +1 more source
Scientific Reports, 2023 CoCrMo and Ti6Al4V are widely used in medical, dental and 3D printing technology, allowing the accurate fabrication of geometrically complicated structures.
Mirjam Bajt Leban +2 more
doaj +1 more source
AIP Advances, 2021 Several methods have been used to optimize performance of magnetic elastomers by controlling the microstructure, such as magnetic annealing. Another way to introduce anisotropy is Fused Deposition Modeling (FDM), which has been shown to manipulate the ...
Thomas M. Calascione +4 more
doaj +1 more source
Enhancing Mechanical Properties of Polymer 3D Printed Parts
Polymers, 2021 Parts made from thermoplastic polymers fabricated through 3D printing have reduced mechanical properties compared to those fabricated through injection molding. This paper analyzes a post-processing heat treatment aimed at enhancing mechanical properties
C. Amza +4 more
semanticscholar +1 more source
Journal of Architecture, Art & Humanistic Science, 2017 The research aims to establish the Arab identity in order to market contemporary printed fabrics that bear the Arab distinguished character. This is to be done through taking advantage of the Arab calligraphy and its aesthetics that distinguish it from ...
Mona Ibrahim, Noha Mohamed
doaj +1 more source
FEM for tensile specimens printed in vertical position B and made of ABS+ material [PDF]
Journal of Research and Innovation for Sustainable Society, 2023 3D printing is finding more and more applications in the industrial field and an investigation is required by material categories and by printing positions of the mechanical properties and how the respective landmarks behave in terms of displacements ...
C Babiş +5 more
doaj +1 more source
Materials Research Express, 2021 This study aims to systematically experimental investigate the influence of infill-patterns (IPs) on specific mechanical responses of parts fabricated by fused deposition modeling (FDM).
M. Moradi +3 more
semanticscholar +1 more source
Printed Graphene Derivative Circuits as Passive Electrical Filters
Nanomaterials, 2018 The objective of this study is to inkjet print resistor-capacitor (RC) low pass electrical filters, using a novel water-based cellulose graphene ink, and compare the voltage-frequency and transient behavior to equivalent circuits constructed from ...
Dogan Sinar, George K. Knopf
doaj +1 more source
Development of Solar-Powered Water Pump with 3D Printed Impeller
Open Engineering, 2021 This study discusses a solar-powered water pump system with 3D printed impeller which was developed to serve as water irrigation to small and medium farms in Bataan, Philippines.
Andres Nelson S.
doaj +1 more source
Electrochemical characterization of commercial and home-made screen-printed carbon electrodes [PDF]
, 2003 Screen-printing technology is widely used for the mass-production of disposable electrochemical sensors. The practical utility of carbon screen-printed electrodes has been exploited, despite the fact that little is known about the nature of the ...
Killard, Anthony J. +2 more
core +2 more sources