Controlling M-A Constituents and Bainite Morphology for Enhanced Toughness in Isothermally Transformed Low-Carbon Ni-Cr-Mo Steel. [PDF]
Materials (Basel)Ji G +6 more
europepmc +1 more source
Effects of Solid-Solution Temperature on Microstructures and Mechanical Properties of 2200 MPa Grade Secondary Hardening Steel. [PDF]
Materials (Basel)Yang C +6 more
europepmc +1 more source
The Effect of Cryogenic Treatment and Tempering Duration on the Microstructure and Mechanical Properties of Martensitic Stainless Steel 13Cr-2Ni-2Mo. [PDF]
Materials (Basel)Fatih MRR, Chen HJ, Lin HC.
europepmc +1 more source
Related searches:
Abnormal relationship between Ms temperature and prior austenite grain size in Al-alloyed steels
Scripta Materialia, 2017Abstract It has been generally accepted in the literature that the decrease in prior austenite grain size leads to a decrease in Ms temperature in steels. However, in the present study, it is found that Ms temperature increases with the decrease of prior austenite grain size in steels with an addition of Al content higher than 1 wt%.
Huang, M, ZHU, KY, Magar, C
openaire +5 more sources
Factors affecting prior austenite grain size in low alloy steel
Journal of Materials Science, 2006The effect of varying normalising and hardening temperatures on the prior austenite grain size in a low alloy Cr–Mo–Ni–V steel has been examined. An initial relative insensitivity of grain size to increasing austenitising temperature was observed followed by a sudden growth of grains at approximately 1000 °C. A detailed study of the precipitates in the
S. Maropoulos, S. Karagiannis, N. Ridley
openaire +1 more source
The Effect of Austenitizing Temperature on Prior Austenite Grain Size in Martensitic Cast Steel
Solid State Phenomena, 2013The GX12CrMoVNbN9-1 (GP91) cast steel belongs to a new group of high-temperature creep resistant cast steels being introduced to the power industry. The cast steel is characterized by higher mechanical properties in comparison with the low alloy Cr – Mo or Cr – Mo – V cast steels used so far.
Grzegorz Golański +2 more
openaire +1 more source
Influence of Repeated Quenching After Carburizing on Prior Austenite Grain Size
Materials Science Forum, 2007High strengths and impact values are required for carburizing steels used for automotive drive train parts. It is well known that the finer-grain microstructures are favorable for these properties. In this study, with a view to effective refining of grain size with controlling the alloying elements, influence of Mn and Cr content on prior austenite ...
Takeshi Fujimatsu +3 more
openaire +1 more source