Results 141 to 150 of about 1,003,843 (220)

Energy‐Based Characterisation of Earthquake Damage in Masonry Infills Through Combined In‐Plane and Out‐of‐Plane Experimental Tests

open access: yesEarthquake Engineering &Structural Dynamics, Volume 55, Issue 13, Page 3302-3318, 25 October 2026.
ABSTRACT The seismic capacity of structural systems/members is usually defined in terms of deformation thresholds. Although this is effective in many circumstances, disregarding cumulative quantities such as hysteretic energy may be ineffective when low‐cycle fatigue is relevant (e.g., long‐duration ground motions, very soft soils, ground‐motion ...
Roberto Gentile   +11 more
wiley   +1 more source

Surrogate‐Based Time‐Continuous Seismic Fragility Assessment of Corrosion‐Deteriorated Reinforced Concrete Bridges Under Climate Change

open access: yesEarthquake Engineering &Structural Dynamics, Volume 55, Issue 13, Page 3338-3362, 25 October 2026.
ABSTRACT Seismic fragility assessment of reinforced concrete (RC) bridges exposed to corrosive environments must reliably capture time‐dependent deterioration impacts. Climate change compounds this challenge through nonstationary temperature and humidity variations that accelerate bridge corrosion.
Yexiang Yan, Yazhou Xie
wiley   +1 more source

Ultrasonic Vibration Assisted Laser Processing: A Hybrid Paradigm for Extreme Surface Enhancement

open access: yesRare Metals, Volume 45, Issue 10, October 2026.
ABSTRACT Traditional laser processing techniques offer many advantages, but they often encounter limitations such as heat‐affected zones, recast layers, residual tensile stresses, and poor surface finish. The integration of ultrasonic vibration (UV) presents a promising hybrid approach to overcome these challenges by introducing beneficial effects like
Aziz Ul Hassan Mohsan   +6 more
wiley   +1 more source

Vacuum Infusion as a Processing Route for Transparent Wood Laminates

open access: yesPolymer Composites, Volume 47, Issue 17, Page 15441-15455, 10 September 2026.
Schematic representation of the fabrication route for transparent wood laminates, including wood veneer delignification, epoxy resin impregnation by vacuum infusion processing, and the final TW‐1 transparent wood laminate. ABSTRACT Transparent wood (TW) has attracted increasing attention as a bio‐based material for daylighting and building‐envelope ...
Letícia Zimermann Pires   +7 more
wiley   +1 more source

Molecular Dynamics Studies of Shape Memory Polymers: From Bead–Spring Models to Atomistic Simulations

open access: yesAdvanced Engineering Materials, Volume 28, Issue 17, 9 September 2026.
Coarse‐grained (left) and atomistic (right) models of the shape memory polymer ESTANE ETE 75DT3 are shown schematically. The two representations bridge molecular detail and mesoscopic description. Both models capture shape memory behavior, linking segmental mobility and conformational relaxation of anisotropic chains to macroscopic recovery, and ...
Fathollah Varnik
wiley   +1 more source

Home - About - Disclaimer - Privacy