Results 121 to 130 of about 204,238 (306)
Topological model for machining of parts with complex shapes [PDF]
, 2012 Complex shapes are widely used to design products in several industries such as aeronautics, automotive and domestic appliances. Several variations of their curvatures and orientations generate difficulties during their manufacturing or the machining of ...
Bernard, Alain +2 more
core +2 more sources
Advanced Engineering Materials, EarlyView.Carbon nanomaterial‐reinforced epoxy composites exhibit pronounced piezoresistive behavior, enabling intrinsic damage sensing under cyclic and fatigue loading. This review critically compares carbon nanotube and graphene systems, correlating filler content, percolation threshold, and gauge factor with sensing stability and damage evolution.
J. M. Parente +3 more
wiley +1 more source
HorticulturaeTree peony is well-known for its ornamental value, medicine function, oil, and edible use. However, the difficulty in propagating tree peony impedes its cultivation and industrial advancement.
Dongli Li +3 more
doaj +1 more source
A generalised approach to torsionality maximisation in longitudinal-torsional ultrasonic devices [PDF]
, 2011 A longitudinal-torsional vibration mode has many applications in ultrasonic systems. Obtaining this behaviour could be achieved either by coupling the longitudinal and torsional modes or by degenerating the longitudinal mode, but the results may be ...
Al-Budairi, Hassan +2 more
core
Advanced Engineering Materials, EarlyView.Thermomechanical fatigue tests of laser beam powder bed fusion (PBF‐LB) Inconel 718 show that the additively manufactured material reaches almost the lifetimes of conventionally‐rolled material under no‐dwell conditions. Introducing dwell times at the maximum temperature markedly reduces the lifetimes due to pronounced grain boundary sliding associated
Stefan Guth +6 more
wiley +1 more source
Surface roughness modeling of CBN hard steel turning [PDF]
, 2018 Study in the paper investigate the influence of the cutting conditions parameters on surface roughness parameters during turning of hard steel with cubic boron nitrite cutting tool insert. For the modeling of surface roughness parameters was used central
Ješić, D. +5 more
core
Size-independent Shear Band Formation in Amorphous Nanowires made from Simulated Casting
, 2010 Molecular dynamics simulations indicate that surfaces strongly influence the strain localization behavior of amorphous nanowires in tension. A sample preparation routine that simulates casting was employed to facilitate the relaxation of the sample ...
Shi, Yunfeng
core +1 more source
Advanced Engineering Materials, EarlyView.This article presents the design, modeling, and characterization of air‐pressure–actuated programmable vibroacoustic metamaterials (PVAMM). The study focuses on leveraging air pressure to dynamically tune resonance frequencies for effective noise attenuation.
William Kaal +2 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm +5 more
wiley +1 more source