Results 171 to 180 of about 357,463 (323)
The criteria to classify body-proportionality of the small for gestational age newborn: a scoping review. [PDF]
Karadavut AB+3 more
europepmc +1 more source
Picosecond direct laser interference patterning (DLIP) enables precise microstructure fabrication on stainless steel. Using a multiscan approach, high‐aspect‐ratio patterns are achieved. Fluence influences structure growth and homogeneity, with smaller periods yielding better uniformity.
Fabian Ränke+5 more
wiley +1 more source
Articulating the need to minimize moral incursions in research : The least infringement condition. [PDF]
Sugarman J.
europepmc +1 more source
Discussion: “Vent Effects on the Response of a Proportional Fluid Amplifier” (Healey, A. J., 1968, ASME J. Basic Eng., 90, pp. 90–96) [PDF]
P. A. Orner
openalex +1 more source
This work reveals the phase composition and quantitative morphology analysis of precipitation‐hardened Fe32Cu12Ni11Ti16Al29 complex‐concentrated alloy. The precipitates are shown to have a high coherency. Morphology transition between sphere, cuboidal, and elongated morphology is observed. Finally, the overaging behavior is captured using microhardness.
Rostyslav Nizinkovskyi+4 more
wiley +1 more source
Safety, Tolerability, and Pharmacokinetics of NorUrsodeoxycholic Acid (Shilpa Medicare Limited, India) in Healthy Adults: Results From a Phase I Open-Label Dose-Escalation Study. [PDF]
Panuganti VK+5 more
europepmc +1 more source
Toughness of Confined Auxetic Foams
Auxetic (negative Poisson's ratio) materials offer benefits such as impact mitigation, thermal insulation, vibration damping, and reduced shear strain, although their fracture mechanics are largely unexplored. This study investigates damage initiation and propagation in confined re‐entrant auxetic foams from polyurethane via experimental ...
Adrianos E. F. Athanasiadis+3 more
wiley +1 more source
A simulative evaluation of triply periodic minimal surface (TPMS) structures for an elastocaloric application under compressive load is performed. For the evaluation of the structure's performance, surface/volume ratio, generated heat and invested mechanical work are taken into account and are compared to a tube as a reference specimen.
Michael Fries+3 more
wiley +1 more source
Initial Characterization of a Multi-Wire Proportional Chamber Positron Camera [PDF]
C. B. Lim+5 more
openalex +1 more source