Results 181 to 190 of about 9,382,737 (353)

Feasibility of Nitrogen as a Carrier Gas for Inconel Cold Spray in Hydropower Application

open access: yesAdvanced Engineering Materials, EarlyView.
N2, despite being nearly two orders of magnitude cheaper than He, is a feasible carrier gas for cold spray Inconel coatings in hydropower repair applications when higher gas temperature and pressure are used. Reducing powder size significantly improved cavitation resistance, while the addition of fine chromium carbide particles further enhanced erosion
Tianhao Wang   +4 more
wiley   +1 more source

Impact of soy- and milk-based yogurts on enamel preservation: erosion and abrasion under simulated conditions. [PDF]

open access: yesClin Oral Investig
Kim RR   +6 more
europepmc   +1 more source

Comparison of Triply Periodic Minimal Surface Energy Absorbers Under Uniaxial Compressive Loading

open access: yesAdvanced Engineering Materials, EarlyView.
This study investigates LCD 3D printed Triply Periodic Minimal Surface (TPMS) structures as mechanical energy absorbers. By comparing various base designs and layered combinations under uniaxial compression, it identifies that a Diamond‐Gyroid sandwich structure offers superior performance.
Sergej Grednev   +2 more
wiley   +1 more source

The role of 316 SS surface finishes in enhancing corrosion protection of conducting polyaniline coatings. [PDF]

open access: yesRSC Adv
Tran DM   +7 more
europepmc   +1 more source

Intestinal alkaline phosphatase regulates protective surface microclimate pH in rat duodenum

open access: yesJournal of Physiology, 2009
M. Mizumori   +5 more
semanticscholar   +1 more source

Influence of Si Content and Milling Duration on the Microstructure and Mechanical–Tribological Properties of AlCoCrFeNiSi High‐Entropy Alloys

open access: yesAdvanced Engineering Materials, EarlyView.
Si‐doped AlCoCrFeNi high‐entropy alloys are synthesized by mechanical alloying to reveal the effect of Si content and milling time on phase evolution, microstructural refinement, and tribological behavior. A transition from FCC to BCC structure, significant grain refinement, and enhanced hardness and wear resistance are achieved, with the 4 at% Si ...
Mustafa Okumuş   +2 more
wiley   +1 more source

Microstructure, Thermal Transport, and Dry‐Sliding Tribology of Powder‐Metallurgy Al7075 Composites Reinforced With Sol–Gel‐Derived ZnO–rGO Hybrid Nanoparticles

open access: yesAdvanced Engineering Materials, EarlyView.
Sol–gel‐derived ZnO–rGO hybrid nanoparticles enable Al7075 powder‐metallurgy composites to achieve concurrent gains in hardness and thermal conductivity while markedly lowering friction and wear. The hybrid architecture couples ZnO‐based load support with rGO‐assisted lamellar sliding and heat spreading, revealing a promising route toward lightweight ...
Bunyamin Aksakal   +3 more
wiley   +1 more source

Anti-Corrosion Properties of Tantalum-Based Composite Films Prepared by Atomic Layer Deposition. [PDF]

open access: yesNanomaterials (Basel)
Xu G   +8 more
europepmc   +1 more source

Electrified Damage in Motion Systems

open access: yesAdvanced Engineering Materials, EarlyView.
The electrified damage in motion systems is a fundamental framework presenting the degradation pathway arising from the coupling of electrical energy transport with mechanical contact and interfacial chemistry. The framework positions electrified damage as a distinct degradation regime with unique characteristic surface morphologies and failures of ...
M. Humaun Kabir   +2 more
wiley   +1 more source

Home - About - Disclaimer - Privacy