Stress distribution in bone around an implant-supported three-unit fixed dental prosthesis using two different computer-aided designing/computer-aided milling provisional crown materials: Milled polymethylmethacrylate and milled polyetheretherketone – A finite element analysis [PDF]
Background: Occlusal loading of osseointegrated implants is believed to be an essential determining factor in the long-term success of an implant treatment.
Swagata Laxmi Barua +4 more
doaj +2 more sources
Introduction: Dental caries remains a constant problem in clinical practice. The rates of recurrent caries around long-term provisional restorations may be even higher due to poor marginal adaptation and less stable materials.
Ravi Joshi +5 more
doaj +2 more sources
Evaluation of Shear Bond Strength of Various Chairside Reline Materials to 3D Printed Provisional Crown Resins Following Surface Treatment [PDF]
Background: The reline material and interim base should bond well in provisional restorations. Few research examined 3D-printed restoration-relining bonding.
Shahd Alshahrani, Manal R. Alammari
doaj +2 more sources
Mechanical performance of contemporary provisional crown materials: insights for clinical decision-making [PDF]
The objective of this research was to evaluate and compare the flexural strength and practical uses of provisional crown materials such as self-curing polymethylmethacrylate (PMMA), heat-curing PMMA, self-curing temporary acrylic resin (Tempron), fast ...
Kiran Shankaraiah Palakurthy +2 more
doaj +2 more sources
Comparative Evaluation of Flexural Strength of Provisional Crown and Bridge Materials-An Invitro Study [PDF]
Introduction: Provisional restorations serve a key role as a functional and esthetic try-in for the design of the final prosthesis. During selection of materials for this restoration, clinicians must consider physical properties, ease of handling ...
Ankita Singh, Sandeep Garg
doaj +2 more sources
Comparative evaluation of mechanical and physical properties of provisional crown and bridge materials fabricated using milling, three-dimensional printing and conventional methods: An in vitro study [PDF]
Aim: To evaluate and compare the mechanical and physical properties of provisional crown and bridge materials fabricated using milling, three-dimensional (3D) printing, and conventional methods. Settings and Design: This was a comparative in vitro study.
Sridevi Marothi +5 more
doaj +2 more sources
Bond Strength of Reline Materials to 3D-Printed Provisional Crown Resins [PDF]
Nathaniel C Lawson +2 more
exaly +2 more sources
3D Printed Versus Conventionally Cured Provisional Crown and Bridge Dental Materials [PDF]
Anthony Tahayeri +2 more
exaly +2 more sources
An Injection Layering Technique of Bonded Provisional Veneers at the Early-stage Crown Lengthening: A Case Report [PDF]
Esthetic crown lengthening followed by ceramic veneers can be performed for a patient with a gummy smile and defective teeth. However, definitive ceramic veneer restorations can be achieved after 3–6 months of surgery.
Alisa Tapananon +1 more
doaj +1 more source
Introduction: Brushing of provisional crown material using a toothbrush and abrasive toothpaste induces surface roughness. This study, therefore, aims to determine the difference in surface roughness on provisional crown materials after brushing with ...
Halimatutsahdia Aritonang +2 more
doaj +1 more source

