Results 61 to 70 of about 87,842 (198)
Modelling of a pull-flow production system with dynamic buffer stock control
Informatyka, Automatyka, Pomiary w Gospodarce i Ochronie ŚrodowiskaIn modern industrial logistics, efficient production relies on synchronizing raw material supply with real-time demand to minimize waste and improve performance.
Saad Elbaraka +5 more
doaj +1 more source
Sequencing mixed-model assembly lines in just-in-time production systems
, 2003 This thesis was submitted for the degree of Doctor of Philosophy and awarded by Brunel University.This thesis proposes a new simulated annealing approach to solve multiple objective sequencing problems in mixed-model assembly lines.
Mohammadi-Khashouie, Ghorbanali
core
Achieving food security for one million sub-Saharan African poor through push-pull innovation by 2020 [PDF]
, 2014 Food insecurity is a chronic problem in Africa and is likely to worsen with climate change and population growth. It is largely due to poor yields of the cereal crops caused by factors including stemborer pests, striga weeds and degraded soils.
Pickett, J. A. +14 more
core +1 more source
Real Time Part Input Control of a Pull Production System by Finding IF-THEN Rules
Journal of Advanced Mechanical Design, Systems, and Manufacturing, 2007 This paper considers the part input problem of a production system where two Flexible Transfer Lines (FTLs) consisting of an up-stream production line and a down-stream production line while operating under Just In Time (JIT) production management.
Rizauddin RAMLI +2 more
doaj +1 more source
Pull System in Lean Production: a critical analysis of parameters influencing kanban sizing [PDF]
openThis master’s thesis investigates a new approach of pull systems sizing in lean manufacturing, focusing on two key applications: purchasing and production.
DOTTO, ANDREA
core
Energy saving by switch-off policy in a pull-controlled production line
, 2018 The control of the consumption during the machine idle periods can support energy saving policies in manufacturing systems. The strategy to switch-off the machines reducing the energy consumed during the idle periods can lead to important energy saving ...
Renna P., Paolo Renna
core +1 more source
The Journal of Engineering, 2019 The fractional slot permanent magnet synchronous machines are well-known for their low torque ripple. However, in mass-production machines, not all the permanent magnets are identical due to the manufacturing tolerances and new torque harmonics could ...
Sergio Zarate +5 more
doaj +1 more source
Modelling and analysis of pull production systems
, 1995 Cataloged from PDF version of article.Includes bibliographical references.A variety of production systems appearing in the literature are reviewed in order to develop a classification scheme for production systems.
Kırkavak, Nureddin
core
Método de aplicação da produção nivelada em sistemas de manufatura repetitiva com produção em lotes [PDF]
, 2008 Dissertação (mestrado) - Universidade Federal de Santa Catarina, Centro Tecnologico. Programa de Pós-Graduação em Engenharia MecânicaA Toyota - a maior montadora de automóveis do mundo - desenvolveu métodos associados ao planejamento e controle da ...
Araújo, Luciano Fonseca de
core
Customized Pull Systems for Single-Product Flow Lines
Traditionally pull production systems are managed through classic control systems such as Kanban, Conwip, or Base stock, but this paper proposes ‘customized’ pull control. Customization means that a given production line is managed through a pull control
Gaury, E.G.A. +2 more
core