Results 11 to 20 of about 173,142 (263)
A Multi-Objective Optimization of Secure Pull Manufacturing Systems
Applied Sciences, 2022 This paper aims to optimize the losses of the current manufacturing systems to perform the Just in Time (JIT) system and minimize the time, labor, and material in the manufacturing process.
Samia Elattar +2 more
doaj +1 more source
Steering Pull Model and Its Sensitivity Analysis
Applied Sciences, 2020 When a vehicle goes on the straight road with a bank angle, a steering pull makes the driver exert a constant steering torque to the steering wheel, which causes an annoying steering feel to the driver.
Seong Han Kim, Min Chul Shin
doaj +1 more source
A mathematical control for the pseudo-pull-in stability arising in a micro-electromechanical system
Journal of Low Frequency Noise, Vibration and Active Control, 2023 A micro-electromechanical system’s reliability depends strongly upon its periodic motion; however, the pull-in instability might arise when the applied voltage is high enough.
Qian Yang
doaj +1 more source
Simulation and Application to Measure Comparable Performance of Push,Pull and Hybrid Manufacturing Systems [PDF]
Engineering and Technology Journal, 2009 In this paper we are going to integrate the most popular production systems nowadaysthat is; push ,pull production system, ,then we compare the performance of the integratedproduction model or the hybrid outcome system to push and pull, by introduce a ...
Hussein S. Ketan, Nahidh Jaffar K
doaj +1 more source
A comparative study and a proposal of a decision support system for the pull systems
Gazi Üniversitesi Fen Bilimleri Dergisi, 2019 Pull system is a production approach that material movement is triggered by a signal. Although the pull system is usually used as a synonym of kanban system, it has been seen that kanban does not work well in some production environments, and some pull ...
İhsan EROZAN
doaj +1 more source
Experimental & FEM Analysis of Orthodontic Mini-Implant Design on Primary Stability
Applied Sciences, 2021 The main objective of this research is to establish a connection between orthodontic mini-implant design, pull-out force and primary stability by comparing two commercial mini-implants or temporary anchorage devices, Tomas®-pin and Perfect Anchor.
Elmedin Mešić +6 more
doaj +1 more source
Key Success Factors in Implementing Pull Production (Case study: Automotive Parts Manufacturing Industry in Iran) [PDF]
چشمانداز مدیریت صنعتی, 2012 Meeting customer requirements with minimum cost in order to increase the value is one of the main challenges of the organizations, and organizations are looking for effective methods to achieve this aim.
Mahdi Esmaeili, Ali Heidary
doaj
A comparison of push and pull production controls under machine breakdown [PDF]
International Journal of Business Science and Applied Management, 2011 Production control for high-mix production remains a complex issue. Common pull system replenishment generates large works-in-process (WIPs) for each part type, especially under breakdown.
Prakash, J., Feng, C.J.
doaj
Frontiers in Built Environment, 2022 Push planning and pull planning are different approaches used for production planning and control. Push planning uses predetermined dates to control a project, whereas pull planning utilizes the system’s current state.
Malek Ghanem +4 more
doaj +1 more source
Artificial Intelligence in Agriculture, 2020 This paper proposes a calculator for estimation of drawbar pull supplied by mechanical front wheel drive tractor based on nominal input variable of tractor driving mode in two-wheel drive (2WD) and four-wheel drive (4WD), and numeral input variables of ...
S.M. Shafaei, M. Loghavi, S. Kamgar
doaj +1 more source