Results 131 to 140 of about 105,987 (304)
High Entropy Wide‐Bandgap Borates with Broadband Luminescence and Large Nonlinear Optical properties
Advanced Functional Materials, EarlyView.High‐entropy rare‐earth borates exhibit excellent nonlinear optical and broadband luminescence properties arising from multi‐component doping, chemical disorder, increased configurational entropy, and increased lattice and electronic anharmonicity. This formulation enabled us to obtain a large, environmentally stable single crystal with 3X higher laser‐
Saugata Sarker +14 more
wiley +1 more source
MetalsNi–P–WC–BN(h) nanocomposite coatings were fabricated on 20CrMnTi substrates using ultrasonic-assisted pulsed electrodeposition. 20CrMnTi is a low-carbon steel that is commonly used in the manufacturing gears and shaft components.
Yingyue Li +3 more
doaj +1 more source
Advanced Functional Materials, EarlyView.Hydrocarbon membranes are a greener alternative to PFSA in PEM fuel cells, but degrade rapidly from radical attack. We present a novel strategy using poly(vinylphosphonic acid) (PVPA) as a local radical scavenger. Incorporated as an interfacial barrier, PVPA enhances chemical stability and significantly extends membrane lifetime under accelerated ...
Hendrik Sannemüller +6 more
wiley +1 more source
Materials & DesignTwin-wire directed energy deposition-arc (TW-DED-arc) is an emerging technology specifically designed for additive manufacturing (AM) of intermetallics with low-cost and high efficiency. Especially in recent years, TW-DED-arc has proved its capability in
Jianwen Xin +8 more
doaj +1 more source
Conductance‐Dependent Photoresponse in a Dynamic SrTiO3 Memristor for Biorealistic Computing
Advanced Functional Materials, EarlyView.A nanoscale SrTiO3 memristor is shown to exhibit dynamic synaptic behavior through the interaction of local electrical and global optical signals. Its photoresponse depends quantitatively on the conductance state, which evolves and decays over tunable timescales, enabling ultralow‐power, biorealistic learning mechanisms for advanced in‐memory and ...
Christoph Weilenmann +8 more
wiley +1 more source
INFLUENCE OF PULSED CURRENT ON THE STRUCTURE OF COPPER-NICKEL ALLOY DEPOSIT
Izvestia Volgograd State Technical University, 2023 V.T. Fomichev +2 more
openaire +1 more source
Advanced Functional Materials, EarlyView.Dicarboxylate‐modified anionic hairy cellulose nanocrystals exhibit a high selectivity for dysprosium(III) over neodymium(III). This selectivity arises from disordered dicarboxylate cellulose “hairs” that enable cooperative ionic coordination, hydrogen bonding, and strain‐induced conformational shrinkage.
Roya Koshani +6 more
wiley +1 more source
Advanced Functional Materials, EarlyView.ABSTRACT Metal oxide (MOx)‐based NO2 gas sensors typically require high temperatures or ultraviolet light, limiting their practical use. To enable visible‐light activation at room temperature, efficient and stable photosensitizers should be integrated with nanostructured MOx hosts.
Yeonji Yuk +10 more
wiley +1 more source
Trap‐Assisted Transport and Neuromorphic Plasticity in Lead‐Free 2D Perovskites PEA2SnI4
Advanced Functional Materials, EarlyView.An artificial retina built from lead‐free layered perovskite (PEA)2SnI4 converts light input into a persistent photocurrent and sums successive flashes over time. Micro/nanocrystals integrated on electrodes act as synapse‐like pixels that perform temporal integration directly in hardware. This in‐sensor preprocessing merges detection and computation on
Ofelia Durante +17 more
wiley +1 more source
Advanced Functional Materials, EarlyView.In this report, we demonstrate that a crystalline phase of 52nm thick NiFe2O4 can be grown by RF sputtering on top of γ‐Al2O3(8nm)/SrTiO3 at a significantly low temperature (150 °C) without compromising the mobility and carrier density of the 2D electron gas at the γ‐Al2O3(8nm)/SrTiO3 interface.
Amit Chanda +11 more
wiley +1 more source