Fabrication of Dish-Shaped Micro Parts by Laser Indirect Shocking Compound Process
Compound process technology has been investigated for many years on a macro scale, but only a few studies can be found on a micro scale due to the difficulties in tool manufacturing, parts transporting and punch-die alignment.
Huixia Liu+7 more
doaj +1 more source
Effect of Shape, Number, and Location of Openings on Punching Shear Capacity of Flat Slabs
Experimental evidence have proved that punching shear capacity of flat slabs deteriorate with the presence of openings located within the critical perimeter around columns.
Ekkachai Yooprasertchai+5 more
doaj +1 more source
Hot semi-punching and cold scrap removing processes for hot stamping of ultra-high strength steel parts were developed to eliminate laser cutting having low productivity after hot stamping.
Mori Ken-ichiro+2 more
doaj +1 more source
Punching Shear Capacity of Recycled Aggregate Concrete Slabs
This article investigates the punching shear behavior of recycled aggregate concrete (RAC) two-way slabs. Ten 1500 mm × 1500 mm × 100 mm slabs were tested monotonically.
Satjapan Leelatanon+4 more
doaj +1 more source
Columns Cross-Section Shape Effect on Punching Shear in Reinforced Concrete Flat Slabs
Punching shear is one of the possible failures that must be taken into consideration in designing concrete slabs and foundations. Several factors control the occurrence of this failure mechanism, such as slab thickness, concentrated loads, and the cross-
Mohammed Oleiwi
doaj +1 more source
Comparison of Punching Shear Design in Finland According to the Current and the Former Method
In the beginning of 2017 the design method for punching shear in Finland was changed. The method presented in Eurocode 2 was adopted with some nationally determined parameters and rules.
Lehtonen Tuomas+2 more
doaj +1 more source
Calculation of the Load Bearing Capacity of Floor Slabs Considering the Properties of Confined Concrete [PDF]
This article shows the distinctive features of concrete working in the conditions of uneven loading and presents the diagrams of confined concrete deformations. The influence of the loading shape on the floor working in pressing-through is shown.
Tamrazyan Ashot Georgievich+1 more
doaj
Experimental analysis of concrete flat slabs with internal stud-type shear reinforcement [PDF]
This study evaluates seven flat slabs made with reinforced concrete. There are three reference slabs, one of them doesn’t present any shear reinforcement.
Diego Borja Ferreira+4 more
doaj +1 more source
Viscoelastic amplification of the pull-off stress in the detachment of a rigid flat punch from an adhesive soft viscoelastic layer [PDF]
The problem of the detachment of a sufficiently large flat indenter from a plane adhesive viscoelastic strip of thickness "b" is studied. For any given retraction speed, three different detachment regimes are found: (i) for very small "b" the detachment stress is constant and equal to the theoretical strength of the interface, (ii) for intermediate ...
arxiv +1 more source
Punching shear performance of star-shaped steel plates reinforced RC slab-column connections
The progressive collapse of flat plate structures due to brittle punching shear failure of reinforced concrete (RC) slab-column connections is a major concern in structural engineering.
Yang Liu+4 more
doaj