Results 51 to 60 of about 57,516 (246)
Low Temperature Sintering of PZT
This paper describes the fabrication and characterization of lead zirconate titanate (PZT) films fired in a liquid-phase sintering process at 900 °C in air. In detail the manufacturing of piezoelectric multilayers with internal pure silver (Tm = 961 °C) electrodes are reported. The feasibility of ten sintering aids in two different volume fractions was
Medesi, A. +4 more
openaire +4 more sources
Bioinspired Adaptive Sensors: A Review on Current Developments in Theory and Application
This review comprehensively summarizes the recent progress in the design and fabrication of sensory‐adaptation‐inspired devices and highlights their valuable applications in electronic skin, wearable electronics, and machine vision. The existing challenges and future directions are addressed in aspects such as device performance optimization ...
Guodong Gong +12 more
wiley +1 more source
Atomic-scale compensation phenomena at polar interfaces
The interfacial screening charge that arises to compensate electric fields of dielectric or ferroelectric thin films is now recognized as the most important factor in determining the capacitance or polarization of ultrathin ferroelectrics.
Ho Nyung Lee +5 more
core +1 more source
Intelligent Acousto‐Electrical Metamaterials (IAM) for Sound Source Detection
Our proposed metamaterial concept enables sound source detection using a single material, in contrast to conventional arrays that require dozens or even hundreds of transducers. We show that the coupled acoustic–vibrational–electrical responses in piezoelectric metamaterials give rise to topology‐governed charge transport, producing distinct voltage ...
Victor Couëdel +7 more
wiley +1 more source
AC low frequency conductivity in PZT PFS ferroelectric ceramics
Low frequency AC conductivity has been studied in ferroelectric ceramics PZT + PFS (Pb[(Fe1/3Sb2/3)xTiyZrz]O3 with x = 0.1 and y = 0.43, 0.44, 0.47) using Fourier transformation of charging and discharging currents.
Osak Andrzej
doaj +1 more source
High Quality Factor Silicon Cantilever Driven by PZT Actuator for Resonant Based Mass Detection [PDF]
A high quality factor (Q-factor) piezoelectric lead zirconat titanate (PZT) actuated single crystal silicon cantilever was proposed in this paper for resonant based ultra-sensitive mass detection.
Ikehara, T. +5 more
core +1 more source
Flexible Dielectric Acoustic Resonator Patch for Tissue Regeneration
A flexible dielectric acoustic resonator patch enables MHz‐range ultrasound generation through resonance amplification without using piezoelectric materials. Conformal integration on a curved substrate allows efficient acoustic delivery to tissue‐mimicking environments.
Donyoung Kang +7 more
wiley +1 more source
Design and optimization of piezoelectric actuators for microflap-embedded micropumps
In this paper, we propose a new method to use cost-effective multi-sheet off-the-shelf piezoelectric material (e.g. PZT) as an actuator for micropumps.
Behzad Parsi +2 more
doaj +1 more source
The perspective presents an integrated view of neuromorphic technologies, from device physics to real‐time applicability, while highlighting the necessity of full‐stack co‐optimization. By outlining practical hardware‐level strategies to exploit device behavior and mitigate non‐idealities, it shows pathways for building efficient, scalable, and ...
Kapil Bhardwaj +8 more
wiley +1 more source
Dynamic Behavior in Piezoresponse Force Microscopy
Frequency dependent dynamic behavior in Piezoresponse Force Microscopy (PFM) implemented on a beam-deflection atomic force microscope (AFM) is analyzed using a combination of modeling and experimental measurements.
Abplanalp M +23 more
core +1 more source

